View Full Version : Forced Induction
- VAFC question
- Anyone have experience with Cusco LSD's?
- P28 ECU for LS w/ old school hondata.. (Hesitation revisited)
- Hondata installation question, Did search
- Greddy customer service... :thumbsdown:
- CR question on mixed parts
- Anyone using an electric exhaust cut-out?
- Greddy to release Turbo Kit for 95 GSR!
- D16 turbo or SI
- removal of ps pump
- restrictive downpipe=backpressure???
- HKS SSQ adapter flanges, 50 or 65 mm???
- washer fluid resevoir removed for turbo
- check out this drag kit for sale, is it worth it?
- JRSC models...will it fit???
- Interesting new EGT gauge...
- Turbocharged 00 ITR
- oil return flange gasket
- vortech need help!!!!!!!!!!!
- What diameter low profile fan did you guys get for your Civic radiator?
- TurboSmart Wastegates any good?
- 2.5 to 3.0" downpipe...
- For all guys with revhard kits that never got filters
- What size injectors?
- P74 ecu auto or manual/hondata question
- Manifold Bolts, What is everyone using? ARP or Stock honda studs?
- Turbo GSR fuel cut off??
- Remove Jumper J12 for Hondata S200?
- B18c1 engine rebuild options
- Just got back from SFP today, got a few questions and I need some tuners input. (LONG)
- has anyone seen civicdrgrcr
- Confucsion on NGK spark plugs
- VAFC hack
- D16y7 tubro setup, what ya think
- Boost spike
- diabloautosports.com, Where did it go?
- Turbo'd ITR's 1/4 mile?
- -- CODE 16 --
- will a blockguard help my block from nos?
- Fuel questions about a built ZC turbo'd
- Long Write Up: This is why piecing together your own kit is better...
- positive boost at idle w/ bosot timing retard from hondata?
- Attn: 400 HP club
- whitch injectors for d16y8
- SOHC Greddy kit... fitment problems with B-pipe??
- D16z6 vs B16 most cost effective?
- Setup thoughts?
- DIY Wideband Laptop hookup?
- Sohc turbo D15b internals how weak???
- 99 Si with JRSC...
- FI in VA MD WV ??? not this week
- how much hp gain will i get?
- Oil clearances for ACL bearings
- HELP HELP ... I need help with ECG SMC PLUS...
- Remove the FMU?
- drag gen3 fitting question
- Clayed new engine. Is piston to head clearance of .030" OK?
- Help Oil
- Question about wiring electronic gauges
- DSM Injectors off what car?!?
- quick smc question! plse
- Might be building a new bottom end...which parts to use?
- are the hks wastegates supposed to come with....
- Is this too big of an I/C for a 2000 SI front with 8-10 psi?
- need help please
- Help gasket!
- removing GSR secondaries /w hondata
- Question about JRSC ...
- prelude comes w/ stock turbo???
- clutch pedal problems, no pedal pressure...
- h22a turbo mani?s
- charge pipe pic request: EF
- Ls/vtec turbo....again. don't reply if you tell me to use the search button
- Revhard Stage 2??
- Up the Boost
- Anyone have pics of the pt cruiser Intercooler????
- NA ported head an FI
- t25+hf manifold= no a/c????
- InlinePro blockguard? Anyone use it?
- anyone else running a t3 with .48 comp; .63 exh??? want some info!!!!
- Need some assistance on fuel setup!!!! please give me your ideas!!
- OT: Any good rotary discussion forums?
- Does Anyone know how much the full-race.com turbo kits costs?
- New Cage pics! Suggestions?
- turbo cartridges
- Wastegate question
- Why is OVERLAP BAD for FI?
- Which Motor for Turbo????
- new motor...smoke?
- GM sychronmesh ?
- need a phone no for DRAG
- What radiator?
- Deltagate Problem
- Camshaft removal question
- * * * Please post your setting witn ECG SMC PLUS and 450 CC * * *
- Looking for pics of G2 Integ's w/ drive side routed IC piping.........
- Clutch slipping with Turbo?
- References Wanted: camp1320.com
- why won't my car start?
- is this bad?
- WET turbo filter bad?
- T/A sensor? JRSC install problems
- Turbo and Stand Alone ??
- Considering buying an IB block, which of these two?
- Greddy Blue Box
- best place to get the NEW golden eagle products?
- Anyone have a differential shim (N) laying around?
- standalone tuning on the eastcoast (NJ)
- Problems with Sohc Turbo, or any engine.. strange and scary
- alright guys I need some pics
- stupid jb weld
- after home many PSI do u need boost retard
- hf turbo 8 valve
- Oversize oil filters w/turbo
- Check out these manifold's
- Denso Injectors = no resistor box?
- Turbo Newbie Question - Difference Between RevHard 2B, 2C, and Civic Si Kit.
- Skunk 2 intake mani for SOHC
- What kind of plugs and plug wires are YOU running?
- EG Owner with FMIC 3" Thick, Help Please
- I need some *small* help..lol
- Move from JRSC to turbo....who's done it??
- Which chances... ZC turbo vs B16B
- V-AFC hack?
- boost/vacumm affected by healights
- What is making my car rev up and down while holding steady at 3 grand?
- SMC not runnin good
- Pics of JG block/work area.
- Whats the safest boost for a Z6 intercooled.
- OK to run a Greddy Turbo kit on my car?
- Tube/Fin or Bar/Plate
- are 450cc to big for my integra?
- is it bad to turbo?
- Loudest Blow-off Valve?
- What are clips for injectors?
- Turbo Oil Feed (WHERE?!)
- urgent need SMC installation instructions
- ...Alternator with F.A.S.T....
- where to buy....tial?
- Turbo size for a 4th gen accord
- injectors, rods, pistons, rings...oh my!
- Crossing over from mobil1 to castro gtx.. yea or nea..
- Attn All DSM 450cc users
- Skunk vs JG
- Toyota Supra 7M turbo on B16A
- Looking for turbo
- tuning... without secondaries
- NGK Plug question...
- Toluene???
- 370cc injectors sufficient for a t3/t4 turbo?
- does flywheel wieght matter for turbo motors?
- Civic Intercooler Help...
- who makes turbokit for 2.3 litre Prelude?
- Chargepipe HELP
- Advice on IC inlet pipe
- GSR cams, ITR Valvesprings/retainers
- For the T25 guys.
- need advise-putting in turbo
- 84.5mm combustion chamber and 84mm bore
- Can I upgrade my fuel lines?
- ITR206 journey to boost
- If I get a new IC will I have to modifiy my piping ?
- thinner head gasket to bump compression?
- water to air daily driveability?
- Intercooler Effiency Questions
- who make best ic core?
- FMU + Inline pump = OBSOLETE!! SMC+ and DSM 450's = New deal (praise for SMC inside)
- Recipe for 13 sec h23 5th gen accord?
- Anyone have 60mm guage bezels?
- greddy type 24 ?
- OT: NA C/R question.
- VAFC with stock injectors and ?? (yes I searched)
- Crossed over to the dark side - pics inside
- Want to learn how to tune? Tuning Seminar.
- F/S Any used JDM or USDM OE engine part!!
- T04 or bigger turbo on there B-series?
- Help with MaxRev install on a 92 LS
- Whats the best way to attach this?
- electronic super/turbo chargers???
- b16 stock internals question...did search
- J&S V.2 Owners Please help
- Problem after fuel pump install???
- Is a turbo time REALLY worth it?
- whitch turbo?
- Just got my ic,turbo and wastegate!!!!
- i need some help from people who know how to tune.
- For those of you that can make or have connections with autometer or similar..
- Need FI guys help in this thread...
- I am being ripped off by Import Builders as we speak. Please read.
- progress of the civic pics
- Need info on bensons sport sleeves ASAP....
- Turbo Timer w/ Clifford Alarm
- OBX manifolds... ?
- stock fuel regulator question
- do you think I can run this much boost?
- Nitrous activation switch
- OT: Pics of Dee's Wrecked Integra
- Can I install my FMU and Missing Link now, and the rest of the turbo kit in summer.
- I/C piping ?
- Turboing 00' Si
- What would you rather squitr w/ cold water, the intercooler or intake manifold.
- Alright..how is your intercooler mounted??
- Carb sticker for GReddy Kit
- ls/vtec turbo with 9:1 pistons?
- People with closed loop wastegate setups...help me with ideas
- Planned setup for this spring.
- VAFC hack and vtec ingament point
- F22b1 home made turbo.... and SMC need some input
- What up guys, I am now a member of the darkside
- wastegate question ?!?
- low vac reading
- Re-torquein ARP headstuds.
- Safest boost level for stock compression B18C1????
- Can I have some help w/ Turbo inspection and downpipe?
- so anyone know what wires to splice for the turbo timer?NEED HELP!! PLEASE READ!!
- where can I get this flange?
- GOT a Cel 13... What to do??
- Has anyone had any problems with weldless oil return bulkhead connectors?
- Looking for turbonetics dealer for a 60-1 w/.70 compressor and 1.0 A/R
- Can the exedy organic racing clutch handle 240-250hp?
- Getting my TIG today;)
- anyone runing the full-race.com turbo kit?
- VAFC Hack, Weird Idle?
- Silicone Hoses
- This a good Deal on t3?
- soon more power to me!
- do they even sell turbo timer wiring harnesses for honda's?
- CAI or Short Ram intake for JRSC?????
- Custom turbo manifold for DSM t25?
- FI Insurance..??
- bottom end no top end
- Spark Racing manifold wont clear ac!!!!!!!!
- Max Rev kit
- RED hot turbo!!
- Gas Porting Pistons?
- Hmm... wastegate malfunctioning? dumping when it shouldn't?
- need nitrous help
- question on engine blowing up
- **Why is my car not boosting in Neutral ???**
- More learning about turbo exhaust.
- intercooler cores
- Personalized plates.......Turbo related!
- Any one know if someone said something under this name in some thread, cause I was just banned.
- sohc turbo?
- Competition Engineering Traction bars and how they compare to others
- 3" downpipe with A/C
- RX-7 550cc in GSR?
- NEED oil drain flange for t25
- Do you guys think this will fit?
- ATTN: If you drive a Turbo'd B18B, please post your 1/4 time and setup, thanks!