View Full Version : Forced Induction
- Spark Racing / AB-Flug GS300 600hp Daily / 800 hp Track
- Johnnyracecar Intercoolers.... any good?
- Fuel Requirements For Boostin a LS
- 400whp/14psi--Civic Radiator VS aftermarket: Which one; Why?
- Good shops in Texas?
- Does anyone still have the Video of GroundZero Motorsports 700Hp Civic??
- going to get tuned soem q's
- how many pounds of boost should i run on a stock civic si
- I'm thinking about buying a t3t04 turbocharged civic for $16,500. Is that good???
- smoke under boost...
- posted here...b/c the turbo peeps are smart..HELP
- Dyno question.
- supercharger vs. turbo
- has anyone used a cheapturbo.com setup yet?
- H-T....I have a problem....Help me!
- 97+ Prelude injectors good for 7 Psi on stock D16?
- Turbo Tune
- Low Boost, Can it create mass problems?
- Proper Tuning
- what numbers should i be putting down (d series)
- ZEX purge
- My new ONE FAB turbo system made to FIT with A/C and 44mm V band wastegate.
- compression #'s (z6 block + y8 head + y8 headgasket + 9.0:1 pistons)
- SFP manifodl and garrett T3/To4e install problem
- Safe to turbo?
- Need Help with DSM Injectors
- Compare Gt35s to Sc61s
- Stolen Turbo teg *pics* is this anyones?
- looking for Good machine shop to assymble Short block nrth/cntrl FL
- How big is 60 and 80mm for exhaust piping?
- T3 SC61 and T4 SC61 whats better
- another iridum sprak plug question for LS turbo
- 11.5:1 compression am i able to boost?
- jrsc @ 11.8:1
- Ok to cut radiator fan blades for turbo?
- EGT and Oil pressure refrences....(D series)
- It's alive!!! details on the last 4months of my life and money
- Whats a good clutch fora street b18b boosted swap in a ek?
- anyone know if the guys who work at secret services on on here?
- Pic request of oil feed lines pls.
- Need suggestions, dyno pulls of 9-15lbs yield same power
- CRX TURBO!?!?!?? HELP!!!!!
- plx wideband question
- blowoff valve opinons here!!!!
- Huge Hondata/Nitrous problem.
- is a B16A1 interchangeable with a B16A2
- Anyone on HT rockin the LHT JRSC intercooler? opinions?
- where to buy chargepipes?
- wastegate making sound
- MY current setup
- sizing denso plugs?
- where to buy a engine management
- I Can't Hold It Any Longer.....Details of New Build Inside!!!!!!!
- Does compression ratio affect spool time?
- spark plugs.. black base but white tips???
- after boosting a little while when come to a stop,car stall's
- do i require a fuel pump with my setup?
- Where to buy, greddy flanges/gaskets?
- Best stock block/head combo for turbo?
- p28 run an ls?
- only limit is 93 octane. how would you build it?
- When it's inspection time for us boosted folks
- my wastegate stays open at idle :(
- How safe is it to be untuned, looking for a good write up.
- egt probe for vdo gauge?
- ideal air fuel ratio at out of boost in WOT...
- what do you use for management?
- intercooler piping question
- Let me see your E-Manage maps!!
- '99 Si Wheel hop...Would new springs, shocks, struts help?
- What Bends do I need to make intercooler piping?
- Thinkin of switching to Hondata from AEM... or going... gasp... NA w/ stock ECU
- VAFC TPS% jumping all over the place?????? running like shit
- Soldering Problems with Turbo Timer on 97 Civic
- What boost should i run
- switching from dry to direct port
- Anybody make there own intercooler piping?
- are nitrous bottles interchangeable
- cp pistons - d-series - ring gaps
- Post pics of your aluminum or SS intercooler piping
- JRSC on B18C1 at 11 psi
- which turbo should i pick
- TUrbocharged Civic Ex?
- Smoke coming out of flex on the downpipe. Is it normal?
- HONDATA RPM Surges & Check Engine Light Blinks
- Broke my knock sensor. Will I loose any performance or have problems?
- Ring Gap Size?
- can i hook wastegate to nipple on intercooler pipe??
- Oil squirters...Needed or not?
- Shifting Problems PLEASE HELP!!
- not boosting past 5psi need help truoble shooting
- Is it ok to run 2.25 exhaust with turbo on gsr?
- toga main and rod bearings
- spark plugs are black...turbo sputters top end
- AFC HACK All Done...WTF Now?
- Bad knock sensor
- RevHard Manifold and a/c?
- to turn up boost or not? help
- CRP turbo manifolds
- Inline Pro IC piping on ek?
- Advice on my 2001 ek coupe 1.6 vti
- air fuel ratio and timing for 8 pounds and 75 shot?
- Turbo setup what do i need??
- cp piston owners
- turbocharge and emission in minnesota?
- good welder in socali?
- turbo i dont know anything about it can you tell me
- Post your clutch and horsepower let's see what works
- What do I "EXCACTLY" need for a custom turbo kit
- Problems with Tuning Fuel Maps
- new B18C5/ full race kit question....
- afc hack question
- intercooler and radiator questions
- 3.6 inch compressor wheel?
- Turbo d16 done, but which msd ignition and coil stuff should i get???
- Detonation Problem with turbo GSR
- NOS: Noszle system?
- Back from the Dyno-turbo gsr pt67
- Engine management for turbo application
- Anyone know a good machine shop in NOVA??
- inconsistant a/f's under boost.
- Hallman MBC Vs. Joe P. MBC
- any turbo'd cars in the bay area that are daily drivers?
- My turbo DA project(almost done)
- my car is back!!!!!! my experience and what ive learned
- ? on turbo setup (95' b18b)
- what size intercooler will fit on my 94 civic coupe DX?
- 91 accord turbo
- Looking on some pricing for a build up, any help would be appreciated
- gsr jrsc on a b18b? can i make if fit?
- intercooler temp gauges?
- Outside Air Temp and pressure and its effect of boosted hondas...
- Flange dimensions
- Drag filter options
- B18C and B16A head gasket...Same? yes or no.
- dumb question for the non daily drivers.
- eagle rods with CP pistons...for those who have these set-up
- High temp paint ?
- Traction with B16a Turbo??
- Are these Vacuum Readings normal?
- has anyone done a GSR tranny LSD swap?
- OK to drive boosted with no fuel management??
- Would a faulty FPR raise fuel pressure
- Best turbo for 1/4 times on Ls teg
- Dyno tuning Tri State area?!
- b20 vtec w/jrsc
- ls turbo with greddy kit
- exhaust size piping. And Injector sizing.
- No boost with new turbo.
- Is there anyway a dyno could read wrong?
- Need your opinion and experiences with what external oil cooler to purchase?!!?
- Ls turbo setups
- Critique my plugs after 400 miles....
- Turbo kit, parts needed?
- h22 w/ block guard and head gasket and 18g
- How much boost is safe?
- lovefab mini-me manifold
- I need help identifing a clutch (need pictures)
- question about rod/rodbearing installation and wight problems
- another stock GSR dyno...WHOA 300HP club!!
- installing turbo xs manual boost controller
- Electrical Oil Pressure Gauge Ok?
- Fresh off the dyno, 462 whp, 328 ft/lbs.
- will bfg g force drag 215/50/15 fit on si wheels
- Nitrous setup acting wierd. Intake tube is getting doused with gas, bad nozzle? help!
- Greddy turbo with stock gsr block?
- SC61 trap speeds and psi level..?? DISSAPOINTED...!!
- where's the best prices
- dual fuel pumps?
- intercooler paint
- safeguard classic install on OBD0?
- Turbo timer harness?
- lsvtec back to gsr???
- h23 piston ring gap?
- Boost spikes running off the WG??
- Do you need a boost gauge if you run off the WG???
- The HKS 3037.
- where to get center cartridge?
- I've been JDogg'ed! Another 400whp Sleeper Street Civic On The Prowl. AEM EMS 1.11 tuned.
- Drag 3 intercooler
- where do u get a flange for tdo5h
- how much boost on B18c1 with some internal work?
- boosted-hybrid retune , must read
- Rev Hard Stage2 Kit on SOHC
- Fuel Pump Debate: DOHC VTEC (135lph) vs. Walbro (190/255lph)
- 10:1 cr and pump gas
- My new Nitrous Setup
- Can i disconnect my Hondata S200 and use uberdata?
- turning up the boost on turbonetics deltagate wastegate
- need help,wiring diagram for 2000 civic ex d16y8
- Crankshaft ID
- GSR secondary butterflies
- turbo problem...sputtering until 5000rpms... video inside
- Who sells full oil line kits?
- warboro 255 fuel pump
- Too Large of an injector is bad ?
- HELP! turbo oil leak in dp
- 236 WHP @ 8psi on Stock B16A1
- lightweight wheels on turbo??
- 83mm B18B head gasket??
- What manifold is this???
- stacking GSR IM secondary plates
- Melted Plugs=75 Shot=Stock Timing-LOOK!
- rings?
- Finally Got one of the first full-race h22 manifolds!
- questions regarding LS/VTEC/TURBO - From guys who are ruinning this only please
- 400+hp street clutch
- What ARP Head Studs for Mini Me Turbo?
- turbo kit and now what??
- Monza Super Sequential Blow Off Valve
- Manifold or Wastegate causing creep?
- Burning oil for how longafter new turbo install
- WANTED: Tuner in Twin Cities
- Greddy Boost Gauge Help!!
- lowering compression HG ?
- Recognizing Nitrous
- rod bearing question...
- I need HELP!!! Anyone bought here?
- removing grill
- DTA Race Electronics Engine Management Systems
- need some help on apexi power fc searched and no solution
- arias ring gap
- what kind of gas mileage do you get on your turbo?
- Could 02 sensor cause my car bogg on 5k rpm???
- How often do u retune?
- Need good machine shop in CT?
- Stock block quiestion...
- HELP - turbo hitting fan, 4 bolt setup w/ inline pro
- a/f chart...need some reassurance...
- Question about intercooler for JRSC
- Rocks poked a hole in my Oil Pan. Whats best to do?? HELP!
- bad to run octane booster all the time??
- Blitz DD or HKS SS?
- couple of nitrous questions.......
- Is Greddy Safe to run on Stock block
- Head Work or Head Swap. . . That is the question
- VW head studs for ZC?
- Turbo XS BOV does it need lubrication???
- Running Lean?
- its time!!
- 93 hatch boosted with greddy and emanage.... What next???? need help...
- Slower spool after switching oil weights
- Does anyone know the diameter of Tsudo exhaust?
- Timing issue, HELP
- Safe Nitrous?????
- Help with Fuel Lines???
- GSR turbo installed, weird idle @150-200rpms, need help
- Quick question on where BOV and wastegate are connected to on GSR
- Getting a drag turbo for my gsr
- obd1 injector plugs?