View Full Version : Forced Induction
- endyn / je piston question
- Type R manifold
- what type of fuel pump ?
- Attn: Hondata Users! Need some help with fuel...
- BLUE DIAPHRAM , WITH NOS DRY KITS. ...HELP
- oil line
- Fuel Pressures?
- MAP sensor hook up on turbo B18B1
- Electrical short?!
- For everyone who was wondering the best way to run the oil feed line.
- head gasket for a ZC that lowers compression?
- What to do with Idle Control Motor on aftermarket Intake???
- Too Rich??
- anyone h22 turbo accord
- ok, last time! who's using stock oil pump? high HP??
- Just test fitted the turbo ... and I gave up on Alamo
- b16 or ls/vtec for boost
- FS: Hondata Stage 4B
- Hondata vs ?
- DRAG GEN 3 QUESTION
- How fast could this FWD turboed car run a 1/4 with street tires?
- Leak down test!?!
- where to look to find info on reading compressor maps?
- where do you get a wastegate actuator signal from
- Which Turbine A/R Size
- 310's needed with Greddy turbo kit?
- white smoke from 92 LS turboed hatch
- controlled boost creep!
- Who here has the MOST HP (or best ET) with stock RODS?
- fluttering noise when i shift gears?
- sluggish turbo!
- Good Turbo Kit
- First time @track with Turbo
- What turbo do I need?
- Pulled out plug wire, runs the same.....what could be wrong? (really need help)
- Has this ever happened to anyone and if it is what I think it is when will it stop??
- Ben @ Importparts.com--440cc injectors!!!!
- Does fuel pressure from stock frp rise during boost?
- Vortech SC for a GSR
- those of your guys with a Power FC
- B17A turbo
- Dyno places?
- JRSC & Turbo
- First time to the dyno
- Garret T3/T04E turbo user question
- Sound of wastegate????????????
- How many of you are running a Vortech FMU?
- b18c1 oil pressure
- AUTOMATIC TRANNY COOLER
- here's the RIGHT part for your oil feed line
- Top End Issue!
- What's the max PSI you can go without needing an intercooler.
- AUTO TRANNY WITH BOOST~
- Ancronym Question
- Fuel injector and Engine management questions...
- Real good fuel injector info.
- help me with launching for streets
- how stiff is clutchnet stage 3 ?
- Best Downpipe and Wastegate for a Drag 3 powered R.
- max nitrous on a b18b1
- fuel pump and regulator for 2nd gen integra
- FMAX manifold, comments/better than revhard?
- which is better...?but im gonna be spendin lotsa money
- what do you guys think? This turbo too big?
- Thinking of removing the jrsc and going turbo... comments/suggestions welcome
- ECU
- What is the HP potential at the ground with this combo?
- Turbo is going on...How's my setup?
- Throttle Body Suggestions....
- How important is the S-AFC for the turbo?
- What turbo is in the 1g Eclipse GSX?
- Who here has the MOST HP (or best ET) with stock ignition?
- Chat
- Important JRSC ?'s About Fuel Inrichment Relay 2000 Civic Si
- turbo timer on integra
- ANYONE with turbo kits on there b16 in ther 88-91 civic or crx post on how it went
- What parts do I need to install my turbo ???
- Facts on MF2 (extra injectors).
- NJ MEET-PICS
- largest intercooler
- MAP seen by ECU
- code 71, and icky rings.
- boost controler
- Need External Ignition with Standalone?
- preset camgear
- which cam are better
- Wow, 2nd day after tuning it and blammo! :)
- F-Max turbo kit for 94 honda accord?
- What difference would this make?
- Best clutch for a Drag 3 powered R...
- anyone want to write up a readme on rebuilds?
- What is lag? Please respond!
- Video of me at the track
- Just finished turbo install
- stock fuel rail?
- Turbo B20
- ATTN: Dragonsmp
- Dynoed my GSR
- people wiht ls/vtec turbo
- Best kit for reliable 13's in a GSR
- Z10 Radius arms and Drag 3
- Finally installed the intercooler
- flex pipe.
- boost peak problem
- New pistons and Rods...Break In?
- What type of 'insurance' for a turbo'd B18c1 head?
- Who is currently running crower cams 402 or 403 on turbo ls?
- Injectors questions Greddy Kit owners
- Turbo Specs on Popular Kits
- safe shot of happy spray
- Have questions about hesitation (around 4000rpms, yes I did a search)
- question about clipping
- OPEN WASTE GATE ON VTEC MOTOR ANYONE DONE THIS?
- Cont from "laid to rest" need another turbo. .
- turbo too big?
- Times for a 2001 Civic Dx
- Help! How do you wire up a inline fuel pump?
- Stock Turbo LS run 13's?
- Opinions on best placement for welding the bung for the EGT gauge???
- got a weird prooblem -- can't start car
- Heres a great site w/ great Tech tips.
- long rod DRAG 3 LS enough hood clearance?
- turboXS bypass valve?
- Do Seal Power make rings for b-series?
- another one laid to rest...
- question about car
- wat trim is my turbo????
- Which aftermarket turbo system fits EG with B18c1?
- hondata
- How much can stock sleeves handle?
- Flashing Check engine light
- How much HP have you squeezed out of a DRAG Turbo Kit?
- OT: DFW peoples..wanna meet up tonight ? coffee shop, mall or something...??
- dummy question...
- Will T-25 work?
- Where can I get a Mitsu TD-04H 15G for a good price?
- turbo on d15b2
- how much will 5 psi. take off my 1/4mile time on tha lude?
- What seat pressures are using
- 9:1 or 9.5:1 in a gsr @ 15 psi... witch is better?
- FS: Drag 3 Intercooler piping
- Vortech SC vs JRSC for an '01 GSR
- im hitting just under .2bar.. somethings wrong, i have a few ideas
- Questions for all you NOS junkies! Dry, wet, direct port?!?
- Opinions on a used flywheel
- Blitz Boost Controller will it help????
- TURBO ACCORDS
- greddy turbo timer help needed.....
- New turbo owner here, some questions
- turbo specifications
- Need help FAST if anyone is online tonight!!!
- Hondata question
- Turbo Setup!
- Vortech FMU w/ Walbro 255 High Pressure Fuel Pump question..
- shops neer Chi-town to get a standalone done at.
- Blitz Blow Off Valve!
- DUSTIN could you help
- ECU problems anyone (greddy kit owners)?
- Fuel Pump Dilema!!
- anyone wanna take bets?
- stock gsr clutch on greddy turbo
- Build up for moderate boost
- Greddy 360cc and 660 cc injectors on groupbuycenter.com
- Turbo????
- pics of a few usernames are in!!!!
- Should i be getting any boost in 1st gear? I only get maybe 2-3psi.. Turbo LS
- Why have an oil pressure gauge?
- Interesting evening at Moroso last nite
- Cheapest place for a JRSC?
- LS Tranny = More turbo lag?
- someone wanted to see my t60-2
- JYT guys...IHI setup on b16a
- Anyone good at guessing the trim?
- so? I love my turbo :D
- 4 rib vs 5 rib crank pulley
- Custom kit or Aftermarket kit? Turbo experts need advice
- too much stress on rods?
- High Compression Turbo with stock sleeves Question
- Flex Pipe, where to get one for cheap?
- Max boost efficiency on drag3's IC
- ~~~~How much boost on stock fuel pump???~~~~
- Happy Thanksgiving!!!
- Help Turbo or Supercharger
- AVC-R and wastegate users... LOOK
- kit question
- Thermostat and Radiator Cap
- Is a KKK k26 turbo......
- hytech manifold
- Can't boost >5psi...
- Finally Boosting
- Max bore on a ZC?????????????
- Max HP with stock fuel lines on a 91 Civic Si...
- Any info on GReddy A/F gauge?
- Endyn Supercharger
- N-tercooler
- Copper head gasket after engine build?
- Lean/Rich Gauge
- Do these EGT's sound about right?....
- Coolant issues!
- all those w/ 3" downpipe/carsond cat/thermal exhaust setup
- STOCK VS. AFTERMARKET HEADER?
- Which GMs came with 2 BAR MAPs?
- J&S INSTALL Q. NEED RESPONSE ASAP!!
- who can find some end tanks....?
- NOS set-up: What do u guys think?
- Help me please!!!..
- Please take a look!
- Chat
- 99-00 civic si VS. 99-01 integra LS drag turbo kit/????
- Even more turbo problems...please help.
- Pissing me off...
- turbo position ?
- intake manifold suggestions please!!!
- J&S Safeguard install location Q
- RC 550cc?
- Thermal question
- for you guys getting the maxrev setup or customing your own kit...
- Gunna install GReddy boost gauge....which way?
- Is my Greddy Profec B defective?
- b18c5 and c1 rod question
- FS: Hondata 4b upgrade $400 obo
- what will...
- 15psi would yield what times and traps?
- what to boost???
- Anyone run an air/water IC daily driven?
- Problems!!! Has anyone on here shimmed up the oil pump spring on turbo cars?
- to vtec or not to vtec....
- b16a turbo crx
- What Pistons for LS motor???
- drag gen 3 + xs engineering intercooler core
- Glowing turbo
- please send me all of your turbo video clips(mpeg's etc..)
- Clutch install
- hitting rev limiter with a turbo - is it bad for your engine?
- Zex Nitrous Kit
- anyone running turbo ls crane cams?
- What can go wrong with me running off the downpipe for a day or two?
- PCV valve questions
- Which wastegate?!? Tial or HKS?
- SCE Copper Pro Headgaskets?
- GReddy E-Manage : Anyone actually *used* it?? !
- JB Weld
- Aftermarket radiator with turbo kit?
- What did you do with your old motor???
- What Turbo Should I Use???
- Should I buy an Autometer Air/Fuel gauge? Sway me either way.
- trying to get a IC, can't decide on the size...
- Test-pipe Simulators are here...
- Adjusting fuel delivery for turbo without electonics..
- Hearing whistling noise at WOT