View Full Version : Acura Integra Type-R
- OT:No F1 Monteal 2004!!
- jdm rear strut bar
- Got a RED SRD ?
- Web sites for classified integra parts?
- high idle
- C-pillar harness bar / camera mount for sale
- ITR Door Panels for sale in classified
- Need help on diagnosing a clutch problems...
- PZero Nero Tires – Review
- Will Type R wheels fit Toyota?
- skunk2 stage 1's or ITR/CTR cams
- Toronto R's - Meet.
- Trade: AEM and Apexi N1 for stock parts (MD area)
- Where are Honda's R's?!?
- Anybody have pics of how to connect a ground wire?
- Trade: TODA flywheel for a stock ITR flywheel
- couple pics of the R
- Experience with www.hondaautomotiveparts.com?
- Pic Req: Insight antenna on ITR (or Integra will do)
- CW ITR with Work Emotion Wheels
- Owning an R worth the hassle?
- Underdrive Pulleys?
- Power steering pump removal question.
- Head question. Oil control orifices, etc...
- Those with Arp headstuds, is retorque necessary?
- The complete and unabridged saga of my stolen R. (Saddle up, it's long.)
- Lightweight crank pulley
- Any good alignment shops in the bay area???
- Saw a clone of my car in DC today
- ? about the JDM passenger side vent? I just read the directions on the JDM carbon switches.
- Tire Dimensions for ITR.....
- i need help, and in return, u will get cheap prices.
- Any one know the feels website url?
- Selling My R
- eBay ITR's Bling Bling y0!
- STOLEN CAR
- I'm Back
- The VAFC and Autocross
- what is the 1/4 mile time for a type r?!
- better on racetrack, tein RA or zeal S6?
- How do test if coilovers are blown?
- Calling all We-Todds! Calling all We-Todds!
- RHD JDM DC2 front clip
- Running lean?
- Towing Rig for your hype- ARGGHHH ?
- How much would my R go for?
- OT: www.itr-nc.com is going to get pulled soon
- Not R Related: Valve Adjustment issues
- Toronto ITR Weekend Meet
- attn: Todd00
- Drive Master Cylinder Brake Brace – Review
- Cheap snap-on style valve adjustment tool.
- Need a pic of an AEM CAI installed
- best coilover for your buck??
- Any Toda flywheel install problems?
- Is b16 oil pan gasket the same as ours?
- ECU upgrades
- Header-Tech Header & Exhaust Fitment???
- ITR #98-0106 was stolen last night..
- Maine Forest Pro Rally
- Stock antenna owned!!!
- PICS - Driving along the 'Great Ocean Road', Australia... (56K)
- Getting a Fuel Cell for Project AWD Integra... Anyone have the ohm rating for the Fuel Sender????
- Where to buy J's Racing CF Intake
- Norcal Bay Area Dyno Day!
- Cross drilled slotted rotors
- HID buzz
- Oil pan leaking?
- Going to California August 27th through Sept 1st..
- Need your hep fast guys , thanks
- Warranty questions?!?
- pics from jgtc round 5 FUGI??
- Type R motor ......
- Just picked up some J's racing goodness
- Need help with Rear calipers
- Wrecked the R
- R for sale at Phoenix dealer
- compression and leakdown test results..... regarding warranty.....
- Turbo R, listen to this..
- turbo
- My another track day. PiX
- ITR owners in Vancouver with a little time on their hands. I need your help.
- Car Stolen!
- WTB: Spoon tow hooks
- ECHC pics from VIR (56K)
- T1R axleback muffler
- What kind of power can be made with ITR cams
- Thank goodness for the bypass valve on the CAI
- How to take pics where cars lower than JDM type R DC ?
- o2 simulator...
- raybrig HID kit on a civic EK
- How much would u pay for a theft salvaged Type R?
- Fresh Wallpaper...56K can try...
- 15" or 17" rims?
- Painting brake calipers
- Anybody running endless calipers?
- ITR owned by overweight underpowered nissan :p
- back from baghdad!
- OEM Honda Type R Rear Film Sticker is selling for $40 US at my local Honda dealer...
- replacing strut rod bushings with poly-urethane advisable?
- Hi temp header coating in the Sf bay area?
- Ground Control Coilover Maintenance
- driveshaftshop.com stage 2: post-install vibrations driver's side
- I need a good painter in the S. Fl area??
- ITR # 0975 was stolen yesterday
- holy JDM OEM HID goodness
- spoon n1, street type or race type??
- A mechanical trivia question
- Austrailian taillights?
- FS: Spoon Sports 1.5way Clutch LSD for B series
- code 4 deck
- Hondata tuning rev limit question
- LS tranny internal ?'s
- Compression test results on B18C5
- GM Syncromesh
- Realtime Splitter
- OT: Some Bod "D" else rolling West to So. Cali in a few weeks with Jack and Marc?
- My leakdown results
- JDM Power Folding Mirrors
- wanted to raise my compresion
- JDM ITR Tranny Q's
- cw type r with gunmetal wheels pic
- Color Code for the Red JDM Integra Type R
- ECHC VIR-N Saturday Pictures
- Is it ok to paint a black Type R Yellow??
- Anyone auto X their ITR?
- Anyone use Shell Helix Ultra 5w40 oil in their ITR?
- knocking????
- comptech carbon fiber dash kit
- rocker arm wear with certain (cough TODA cough) cams?
- fun with video maker
- jdm b18c-r, hondata s200/p28, no vtec, settings???
- Had some fun today - few pics
- Body Shops
- Mugen Oil Pan installation Questions
- Compression test question - low numbers on one cylinder
- 9005 silverstar conversion question
- brake upgrades, but still want run 16inch rims?
- Anyone tryed cryotuffing their shit.
- EK9 CTR Cams.
- Skunk2 camber kit - (need torque specs)
- ITR caliper = non R caliper?
- comptech header problem....
- Removed Steering Wheel. NEED HELP!
- What grease do you use on your brake pads
- wheel bearing size
- ACT clutch died ...very pissed off..(link to a long post)
- need type r intake asap!
- CRUD: POSSIBLE EXPO PROBLEM
- itr206....please read turbo question
- Took some pics. of the R today
- Used B18C
- valve stem seals which one??
- Is it bad to put 5qt. of oil?
- Rotational Mass: 15" USDM ITR Wheels (16.8 lbs) vs. 16" Mugen MF10 Wheels (11 lbs)
- Where can I buy a 3 inch silicone boot for my AEM cold air intake?
- Bad news on the ITR motor. Compression test results
- are azenis directional? REVISITED
- **** In-cabin VID from the A1 Ring ****
- JDM LCAs?
- ITR motor - what to do
- Legend GS rotors + itr calipers?
- Anyone with a Hondata Romeditor V3, can you help me?
- quick help
- maintenence required light?
- Technical Vavle adjustment questions.
- sorry dumb JDM R light Q
- JDM ITR QUESTION
- Any NYC Integra Car Clubs?
- Holy $H!^ 20 Honda's broken into in the Raleigh/Cary Area!?
- Has anyone removed the black canister under the Battery?
- Cleaning Mugen Pedals
- Valve Lash and Idle?
- Is anyone Crazy Enough To take the R to.........
- JIC Exhaust
- Gas Tank?
- Smaller front sway bar
- new wheel bearing bad after 170 miles?!
- Oil Leak! I Think the mechanic did it!
- A question For some ITR owners.
- shannonville aug 4th full track
- Tail light installation question
- Toronto INtegra club?
- Removing paint from calipers...
- dirty grind noise
- ef-1 valvetrain and other components?
- Dyno tuning and stock intake
- Tein SS available for Type-R's?
- Problem with tuning with Hondata, pls help
- anyone can post me a picture of a stock ITR air filter
- Pass inspection with jdm front end??
- ctr pistons
- 1998 ITR my baby .... for sale
- How much is NSX front brake calipers?
- HID mount problem
- you can tell that im a newbie!!
- OEM Fog Lights
- What's the code on a 1998 Type R head??
- Exhaust recommendations?
- question about cv joints?
- Anyone have torque specs for Type R cam installation???
- JDM DC2 INTEGRA TYPE-R P73 ODB2 ECU 210HP+
- Aftermarket Momo Wheel Installation (wiring)
- CEL 420 wtf!!
- What is my car worth
- Doe anyone know a guy name Ben driving White 1998 TypeR in Nova?
- oem rubber clutch/brake pad: hook me up!
- Airbox/intake info
- Should I roll out to California with Jack?
- OT: Anyone have a type-r engine for mini pickup?
- I want a splitter too...
- ATS carbon disc brakes?!
- vafc help
- flywheel question
- Ultra M.D.I - Where can i find this? Any info??
- When is the next Vancouver ITR meet?
- JDM Front Conversion
- praise: magic hat #9 - valve adjustment; is it worth learning yourself?
- GM syncromesh tranny fluid results inside!!!
- Spark plug torque
- Need pictures of Stock ITR calipers.
- got back from tuning my car at DSR, results inside
- Hella air horn sound clip:
- 97 JDM ITR are the tail lights the same as USDM??
- Installed the Tein S tech Springs
- T1R intake
- Anyone know where I get a DOT inspection in GA ?
- A little OT: Anyone in CA want a 2001 Type R interior?!
- Anyone have specs for the 4-2-1 Spoon header (2 piece)?
- anyone here own 01-0681?
- HID ballast mount
- Consequence of letting the CV joint destroy itself???
- JDM 98+ Type R rear lip? And UK/Euro bumper question.
- ITR theft prevention: Remove license plate?
- Half-Used Race Tires Kumho ECSTA V700 (225/45/15)
- Charlotte Meet: P1 Sucks!
- ITR or 928?
- Someone buy my stupid Volk wheel!!!!! LOL
- ITR 4 lug conversion
- what you guys think about this master cylinder brace?
- do USDM type-r's have the faux carbon fiber pieces that JDM ones do?
- Northeast Rs - NASA event - Pocono August 30-31
- For anyone considering buying function 7 lower control arms ...
- Anyone looking for an ITR nose bra
- ITR spotting on FL Turnpike
- JDM front conversion from Options Auto?? (anyone buy)
- Anyone know which readily available belt will work with a CTR N1 Crank pulley?
- Help, Pulled CELs this morning
- West Coast kr3w!! (Road trip confirmed) : OT
- what exhaust is the spoon dc2r running ?