Thanks for the Info

 

oh.

 

Actually, already did. It actually came out pretty nice, but before I do more, I realized I should have asked before I began.

The car will see street, but not be show. Think of a white Ugly ED, with interior so I can bring wife and daughter along.

 

I haven't taken any time to figure out my a/c nor fix my climate control. If you have a spare cracked climate control PM me as I will nurse it back to good health. Mine is shot shot shot. **** don't even stay flush with the center console cover. It's screwed. My temp **** arm even broke off. FAIL

I don't know if it's grounded or if the relay is good or not. I had a wedding this weekend out of town and Sunday was kick back and relax day. Thankfully the south isn't ***** hot yet.

 

Do you guys know what wheel bearing to use for a SiR knuckle? I think its teggy

 

http://www.crxmpg.com/

 

update on the short, it was the crappy plug that got spade connected into the wiring harness.

 

Need some help with an issue on the Skunk2 camber kit please.
https://honda-tech.com/forums/suspension-brakes-54/skunk2-ef-front-camber-kit-2515169/

My last post is where the problem is.

 

Anyone have a clear pic of their charcoal canister hooked up with a b16A? I had to change mine and replace some yellow silcone hoses PO did and something didnt look right.

 

would it look the same with it hooked up to a B18a1?

 

I would think so. It shouldnt change, EVER. Unless, like me, you just remove the damn thing. lol

 

^^ ur problem sounds like it is the camber kit itself. I would contact the seller about the product. Damn, I was goin to go get myself one also.

 

Commented in your post. Camber has nothing to do with twitchiness if it's dialed in and correct on both sides. It's your toe that causes this. See post...

 

I just got back from having my oil changed at Acura of Augusta I was neighbors with the lead mechanic there growing up and it was only fitting to have him give the swap a look over and a service. Besides the clutch being strong, he was impressed with the detail and the clean wiring (or lack thereof )

I tried to milk him for some a/c troubleshooting (compressor doesn't kick on) but he said about the same things. Check relays, grounds power wire etc.

And yes, I'll gladly pay someone else to do an oil change. F that.

 

I'm so0o broke right now,spring is pretty much here.

 

i'm with ya.

 

that's the easiest thing you can do to your car, besides chang your air filter

 

I'll take a pic of either, just want to make sure. Cleaning up what I can as I go.

I dont think I will ever make the car as clean as some of these good examples I see, I like mine a little rough around the edges, seen some miles and still gets used. That way I'm not as nervous about just using it.

 

i get my $75 car allowance tomorrow...

 

must be nice

 

a lot of times it goes to something else not car related

 

Like food? lol

 

no...i just find mysel spendin it here and there...i'm horrible at saving

 

I know the feeling. Seeing something I like, I buy it. lol

 

Question: Can you run rubber driver/pass side engine mounts and retain the urethane rear mount on a swapped EF? I'd love less VIBRATION inside my car.