Does anyone know the differnce between the Drag 3 Exhaust mani and the Rev-hard????

 

they are both cast iron
they both fit the same car and T3, T3/t04 turbos
the drag manifold has DRAG stamped on it
but they both fit just the same

 

The drag has the wastegate on the 4th runner, up until recently this has never been an issue but now it seems that when u run a full 3" DP/exhaust system u will experience boost creep..

also I think the Revhard is half Cast iron and half something else, or i may have it confused..


[Modified by DIRep972, 4:30 PM 11/1/2001]

 

Willyou experience boost creep with the Max Rev setup offered by Geoff Z10? Im not sure what runner the waistgate is on?

 

shouldnt have any boost creep from the max rev manifold because the wastegate is off the middle of the manifold where all three runners join