Has anyone ever seen or done this setup?
#1
Junior Member
Thread Starter
Join Date: May 2008
Location: Jacksonville, NC, united states
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever seen or done this setup?
Ok I am currently building a D15B and here is everything I have so far. I just wanted to see if anyone else has done/seen this and what i can expect.
CP pistons (9.0:1)
Crower Rods
450cc RC injectors
OBX fuel Rail
OBX FPR
255LPH Walbro Fuel Pump
P28 ECU (Socketed w/Hondata S100)
Hondata 4 BAR MAP sensor (I know 4 BAR is way over doing it, but it was free)
T3/T4 Turbo
Moshimoto Intercooler Kit
Gripforce Stage 3 Clutch w/Fidanza 8lbs Flywheel.
I will be pushing 10-12 PSI Regularly and 16 at the track. I haven't Replaced the Cam yet because I am having one built, also I will be using the Z6 tranny. I am asking if anyone has seen/done this setup because it is kind of hard to have it dyno'd right now due to the fact I am in IRAQISTAN at the moment. Thank you in advance for any input.
CP pistons (9.0:1)
Crower Rods
450cc RC injectors
OBX fuel Rail
OBX FPR
255LPH Walbro Fuel Pump
P28 ECU (Socketed w/Hondata S100)
Hondata 4 BAR MAP sensor (I know 4 BAR is way over doing it, but it was free)
T3/T4 Turbo
Moshimoto Intercooler Kit
Gripforce Stage 3 Clutch w/Fidanza 8lbs Flywheel.
I will be pushing 10-12 PSI Regularly and 16 at the track. I haven't Replaced the Cam yet because I am having one built, also I will be using the Z6 tranny. I am asking if anyone has seen/done this setup because it is kind of hard to have it dyno'd right now due to the fact I am in IRAQISTAN at the moment. Thank you in advance for any input.
#2
Honda-Tech Member
good luck with your answer, its good to see that someone presumably in the military has time to worry about stuff like this.
i think if i were over there the last though i had would involve building a motor.
free bump.
i think if i were over there the last though i had would involve building a motor.
free bump.
Thread
Thread Starter
Forum
Replies
Last Post
00CIVICSITEIN
Forced Induction
1
03-16-2004 05:47 PM