for all of you who have catch cans like a t1 or similar.

if you are running 2 front fittings on your valve cover and you used either hose end fittings or 2 90 degree fittings, what was the total ammount of steel braided line you used for each line? and if you have 2 fittings on the back of your block, how long were each of those lines(assuming hose end fittings were used and you had 2 drain fittings on your can) need some quick replies so i know what to order.

 

any one??

 

There's at least one thread dedicated to this. I would almost garantee you would have the best response by posting in it. Sometimes this forum is rather dead.