i just hooked up the map sensor. never used a volt meter so not sure how to use it. but when i start the car it starts and then just shuts right back off. not sure whats wrong just don't understand
help

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by zbower7 &raquo;</TD></TR><TR><TD CLASS="quote"> never used a volt meter so not sure how to use it. help</TD></TR></TABLE>

this might be it right there

 

What ecu are you running? Did you make the proper changes in your ecu?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by underpressure02 &raquo;</TD></TR><TR><TD CLASS="quote">What ecu are you running? Did you make the proper changes in your ecu?</TD></TR></TABLE>


exactly what i was trying to squeeze out of him when he posted in the integra forum.

what standalone are you using, why are you running a 3 bar, did you install the wires correctly, etc, etc....his question is TOO BROAD.

 

i have a integra ls that is chipped with hondata and is set up with the boost option. i am running a t3 turbo with 550 injectors and the hondata is set up with a base map 5lb boost cut and is running my 550 injectors does the hondata have to be programed to run a 3 bar map to make it work. i don't understand help

 

The hondata will have to be set up for a 3 bar map sensor. Your problem could be that you installed it incorrectly or maybe you did intall it correctly and it won't run because of the hondata not being set up for it. There is an installation guide for a 3 bar sensor on hondata.com

 

yea i put it on as far as i know correctly i just wasn't sure if the hondata has to get set up to run a 3 bar it or if it will run off what it has
i mean it would just start up and the shut right back off it was werid

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by hoggy &raquo;</TD></TR><TR><TD CLASS="quote">The hondata will have to be set up for a 3 bar map sensor. Your problem could be that you installed it incorrectly or maybe you did intall it correctly and it won't run because of the hondata not being set up for it. There is an installation guide for a 3 bar sensor on hondata.com</TD></TR></TABLE>


^^

 

you may still have other issues, my car started up and idled fine with a 3bar map sensor installed with a stock ecu.