ok i ordered a chipped pm6 from xenocron that comes with 2 basemaps.
one basemap is for my 14b-setup and the other is for my current n/a set-up sorta of a reflash type program.

anyway i took out my stock pm6 and put in my chipped one and it wouldnt start for ****. so i leave it on the on setting and i go over the engine bay and i hear hsssing under the intake manifold so im like wtf?

i put my stock pm6 back in and it starts up fine no problem no hsssing


wtf is going on its either a bad chip or bad ecu any suggestions?
_________________

 

solid cel?

 

its not throwing any codes at all which is wierd it just make a hsss sound in the engine bay and doesnt start

 

help this man out!!! cause im getting ready to do this too and want to know the problem

 

flip the chip 180*. i had the same problem with a PM6 ecu.

 

thanks streetwerks but i already did that let me try it again kinda wierd if you ask me.

 

put the half moon the direction of the ecu plugs, try the other chip too, xenocron is top notch! Prolly something ez

 

sounds like the fuel pump staying on? i suggest you make sure no pins are bent and everypin is cleanly connecting with the female peice on the ecu.

 

well i turned the chip 3 times and the third time it finally worked car turned on nicely problem solved wierd thanks streetwerkz.