I took my civic hatch dx to get my front brake done. and after 2 weeks i decided to put my rims back on and now i run into a problem trying to take off my driver side front wheel. i took all the lug nuts off but the wheel wont come off. i could spend it freely without as it's on the jack stand but i cant find a way to get it off.
i hammer it with the mullet but its not comin off.

need help? i think the mech messed up my wheel by tighten it to much?

hope u guys could help me out ..
over all every wheel came off normaly but accept for the front driver side. so i decide to roll on dounuts another week until i find a way to get it off.

thanks for reading....

 

kick it

 

Put one of your lug nuts back on loosely. Kick the bottom back of it, or use a rubber mallet, hit the same spot.

 

Kick the living crap out of it. Don't use a mallet. KICK IT!!!

 

Keep kickin it....it's bound to come off....

 

Pry bar between the wheel. Some WD40. Worse case pull off entire hub if your wheels allow. If not kick it. Good Luck

 

Survey says...........Kick it.

 

turn around and kick backwards onto the tire

 

Put one nut in a couple thread and wear a boot, then start kicking. If it help do a spin kick