building up an mini me swap....got a few problems.
10-09-2005, 08:18 PM
#1
Member
Thread Starter
Join Date: Apr 2004
Location: Seattle WA
Posts: 1,599
Likes: 0
Received 0 Likes
on
0 Posts
building up an mini me swap....got a few problems.
i am about to start putting this motor together for daily driving for now for all motor and maybe later go on with a nitrous kit or even a JRSC (maybe both).
now heres the setup so far:
D16a6 block
Z6 Vtec head
88-89 D16A1 (p29) pistons
ZEX street/strip camshaft
Walbro 255lph fuel pump
-my questions:
what head gasket should i go with?
should i go with an EX tranny?
will it fit the D16a6 block?
what other things should i look into?
i am also going to strip down the head and block and get them all cleaned up before i put it back together. and nothing will be milled if that helps. all factory specs.
now heres the setup so far:
D16a6 block
Z6 Vtec head
88-89 D16A1 (p29) pistons
ZEX street/strip camshaft
Walbro 255lph fuel pump
-my questions:
what head gasket should i go with?
should i go with an EX tranny?
will it fit the D16a6 block?
what other things should i look into?
i am also going to strip down the head and block and get them all cleaned up before i put it back together. and nothing will be milled if that helps. all factory specs.
Thread
Thread Starter
Forum
Replies
Last Post