dapek

Hey guys/gals, while at a stop my CEL light stays on and once i start accelerating the CEL shuts off and then turns back on when i stop again most of the time. Today i pulled the two pin wiring part to check my codes and when i jump the two together and then turn the key to the ON position the CEL light just stays on and doesn't blink for me to diagnose it? Anyway i could be doing something wrong or any opinions on what could be wrong. It's a b18c5 in a 94 eg. Thanks

dapek

bump, anyone?

AK94GSR

not sure why it comes and goes when you stop and go, but you may want to check grounds and connections.

dapek

grounds and connections are checked and good, I don't think that would cause the lack in being able to pull a code though would it?

trustdestruction

There could be something wrong with the ECU. My old ECU was messed up and would randomly throw a CEL and put the car in limp mode. If I shut the car off, the CEL would go away and I would not be able to pull the code. I replaced the ECU and it hasn't done it since.