Sleeving Companies:ERL vs. GE vs. RS
#1
Honda-Tech Member
Thread Starter
Join Date: Apr 2004
Location: Florence, Ky, USA
Posts: 1,709
Likes: 0
Received 0 Likes
on
0 Posts
Sleeving Companies:ERL vs. GE vs. RS
with my new setup i plan to push ~550whp and want to have the block sleeved for security. now i just can't decide which company to go with.
A local shop has a freshly sleeved ERL block and is asking 1200 for it. i've yet to hear anything bad about ERL, but the cost is a lot more than RS and GE so i can't decide if it's worth it or not.
GE had already sleeved block for 950 shipped but final bore was an additional 150 i think.They also have an excellent warranty.
RS charges 850 for open deck or 1150 for closed deck but requires a core, which i have, and includes final bore,so this seems like the best deal...
Any input to this...are all companies safe bets and will have no problems?
A local shop has a freshly sleeved ERL block and is asking 1200 for it. i've yet to hear anything bad about ERL, but the cost is a lot more than RS and GE so i can't decide if it's worth it or not.
GE had already sleeved block for 950 shipped but final bore was an additional 150 i think.They also have an excellent warranty.
RS charges 850 for open deck or 1150 for closed deck but requires a core, which i have, and includes final bore,so this seems like the best deal...
Any input to this...are all companies safe bets and will have no problems?
#3
Honda-Tech Member
Re: Sleeving Companies:ERL vs. GE vs. RS (CivicVX94)
We use Golden Eagle MFG(since 99 or so) and have never had a problem with their blocks. we are now making over 800 to the tires on one particular block, this block has been run for 2 race seasons now, and a bunch of dyno pulls. headgaskets holding up like champions !!
we just had a huge debate... and it still might be going on...
https://honda-tech.com/zerothread/1853111
there are a few more good ones too.
we just had a huge debate... and it still might be going on...
https://honda-tech.com/zerothread/1853111
there are a few more good ones too.
#5
i ♥ my honda
Global Mod
Global Mod
Re: Sleeving Companies:ERL vs. GE vs. RS (CivicVX94)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by CivicVX94 »</TD></TR><TR><TD CLASS="quote">never even put thought into step decking or copper o rings.... </TD></TR></TABLE>
Just like you didn't put any thought into searching. These dam threads pop up once a week. I run GE with no problems here. I do have copper o-rings.
Just like you didn't put any thought into searching. These dam threads pop up once a week. I run GE with no problems here. I do have copper o-rings.
Thread
Thread Starter
Forum
Replies
Last Post
boostedb18kid
Forced Induction
11
06-11-2007 03:24 PM