need some guidance ...
since this del sol will be my last project (before i buy myself a ford taurus and call it quits), i'm in need of guidance. i've been searching/reading for about 3 months and i have a couple of questions, but let me start out by saying i appreciate any suggestions/criticism posted.
can a b18b1 run completely STOCK (at the crank) 250hp (6-7 lbs of boost) reliably? if not, what would have to be upgraded? i plan on forged rods/pistons but is there anything else i need to worry about? and if i was do downshift at high RPMS will this boosted motor blow?
and finally... how much am i looking on spending? turbo kit including a good fuel managment system. thanks again
can a b18b1 run completely STOCK (at the crank) 250hp (6-7 lbs of boost) reliably? if not, what would have to be upgraded? i plan on forged rods/pistons but is there anything else i need to worry about? and if i was do downshift at high RPMS will this boosted motor blow?
and finally... how much am i looking on spending? turbo kit including a good fuel managment system. thanks again
there are 2 ways of doing the turbo. a kit and piece together. with the latter being cheaper, but the first being easier. i am pulling numbers out of my *** on this, 2500-3000 for a drag kit, and uberdata is free. get a good walbro pump for 180 and some dsm 450's and plan on spending about 400+- for a good tune and your goal should be attainable reliably. it is all in the tuning.
i'm kind of looking for the cheaper route. ie: a custom turbo kit pieced together and i'm kind of looking towards hondata instead of the uber.
Thread
Thread Starter
Forum
Replies
Last Post
JdelMsolG
Forced Induction
10
Aug 31, 2007 10:31 AM



