Can you change a cyp sensor ???
#1
Honda-Tech Member
Thread Starter
Join Date: Oct 2002
Location: Richmond, VA
Posts: 2,175
Likes: 0
Received 0 Likes
on
0 Posts
Can you change a cyp sensor ???
Hey guys, I am working on a obd1 d16z6 swap in my 91 hatch. My distributor started popping a cyp sensor CEL. So I bought a used distributor off a member on h-t and and it is no good. The bearing is bad, but there is no cel now with this distributor for the cyp sensor, so my question is can I switch them out and if so how?
#3
Honda-Tech Member
Re: Can you change a cyp sensor ??? (Si2See)
You can dismantle the distributor to replace the guts IF you have another spare distributor that will not fit. It's not very often I hear of those sensors going bad, so check your wiring first.
I successfully transplanted the sensors from a D16Z6 distributor into a B16A distributor case, so I know it can be done, the sensors are somewhat universal.
I successfully transplanted the sensors from a D16Z6 distributor into a B16A distributor case, so I know it can be done, the sensors are somewhat universal.
#5
Honda-Tech Member
Thread Starter
Join Date: Oct 2002
Location: Richmond, VA
Posts: 2,175
Likes: 0
Received 0 Likes
on
0 Posts
I have two spare d16z6 distributors. One is gone but it has a good cyp sensor, the other one the bearing is fine but it has a cyp sensor code, and I have had it apart but am not sure which one is the cyp sensor
#6
Honda-Tech Member
Well..
B11---orn3----------CYP
B12---wht-----------CYP
According to obd1 pinouts, so take it apart and figure out where the wires go inside the distributer.
think outside the box a little
B11---orn3----------CYP
B12---wht-----------CYP
According to obd1 pinouts, so take it apart and figure out where the wires go inside the distributer.
think outside the box a little
Trending Topics
#9
Re: Can you change a cyp sensor ??? (Si2See)
umm yeah i have 2 distributors also and all of a sudden its throwin a code p1381 i swapped out to the 2nd distributor and still the same and when i start my car if i dont give it gas it will stall i need help i have a d16y8 i dont have alot of money and dont want to spend alot to fix it so if anyone nose where to start looking at the wiring tell me please.
#10
Honda-Tech Member
Thread Starter
Join Date: Oct 2002
Location: Richmond, VA
Posts: 2,175
Likes: 0
Received 0 Likes
on
0 Posts
when i made this thread, i was asking if I could do it so I would have a good backup distributor. if you are getting this code, more than liklely you need to buy a new distributor
Thread
Thread Starter
Forum
Replies
Last Post