Ok, I have some 440's w/ clips and I need to know what color wire goes to which cylinder. If you are standing infront of your engine w/ the hood popped looking down over the engine, Injector 1 starts closest to the timing belt and injector 4 is closes to the distributor correct? Do the yellow/blk wires go on the outiside of the injector or the inside?

 

Correct, from the timing belt it goes 1-2-3-4 from right to left. For the wires, just match them up with the way the clip attaches to the injectors and just splice and solder the new clips.

 

Ok, well the thing is that there is a yellow/blk wire that goes to each cylinder. The other color wire (brn, blue, yellow, red) goes to a corresponding cylinder as well. They will fit in either slot, so that is why I am asking. I need to know if the yellow/blk wire goes on the outer or inner side where it plugs into the injector.

 

Yellow/black is on the tranny side of the engine.

#1 Brown
#2 Red
#3 Blue
#4 Yellow

Sonny

 

Ok, so that would mean that starting from cyl 4 (closest to the distribuotr), it should read:

yellow/blk, yellow...yellow/blk, blue...yellow/blk, red...yellow/blk, brown


or would it plug in opposite like this:

starting from cyl 4 (closest to distributor)

yellow, yellow/blk...blue, yellow/blk... red, yellow/blk...brown, yellow/blk


??

 

so the yellow/blk wire goes on the tranny side of all the injectors?

 

Yes

Sonny

 

Thanks for all of your help Sonny.

 

I don't see how this is possible...when i plug my stock injector clips back in...the yellow black sits on the driverside...how is it possible that the yellow black sits on the tranny side..can i get some pics?

Khoi

 

The yellow/black wire only matters when you are using resistors. This is the wire that comes from the ECU with the signal to fire. The other wire is a ground. The resitor should be wired in line with the yellow/black wire.


If you are using saturated injectors it does not matter which wire connects to each side of the clips.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by brkrnu &raquo;</TD></TR><TR><TD CLASS="quote">

If you are using saturated injectors it does not matter which wire connects to each side of the clips.</TD></TR></TABLE>

Awesome! Thanks!!