ok, I am trying to wire my new b16a2 motor, obd2, its going in my obd2 car, but the motor is jap spec

I am using my united states made d16y8 harness on it, and i have 3 extra plugs on the harness when trying to place it on the jdm b16a, one looks like a coolant temp sensor, and I can see on my friends 99 US si that there is a spot where this would go, btu the sensor isnt there

there is another wire that goes to perhaps the back of the block, but i dont know what its for, again, there is no sensor on the jap motor

there is another that is attacthed to the injector controllers, and on my d16y8 motor it attacthes to somethiung labelled "denso" on top of the fuel rail, but my jdm b16 doesnt have it


basically, i guess just leaving these wires will be fine, because the jd ecu wont look for those wires anyways!



[Modified by topher, 5:45 PM 1/26/2002]