idle problem
Thread Starter
Joined: Dec 2003
Posts: 12
Likes: 0
From: newark, delaware, usa
idle problem
i have a 92 cx with a jspec SIR2 swap , its not holding a constent idle it jumps from 1500 to 3000 rpms. i checked the IAC/TPS/MAP and all the vacum lines and theres nothing wrong i even swapped all the censors with ones i have laying around . i figured id ask here and see if anybody had any insight, ive been racking my brains for a couple days trying to figre it out. the only thing that ever works is putting the car in gear and letting the clutch out and putting load on the motor for a minute with the brake up , sometimes after doing that it will idle fine for a while. thanks in advance.
Honda-Tech Member
Joined: Jun 2003
Posts: 2,072
Likes: 0
From: st.louis, mo, usa
Re: idle problem (Mikey3000)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mikey3000 »</TD></TR><TR><TD CLASS="quote">check if there's any air in your cooling system. do the "bleed air from thermostat housing" procedure. </TD></TR></TABLE>
what does that procedure consist of..pulling a hose off the thermo housing..and let some coolant out?
what does that procedure consist of..pulling a hose off the thermo housing..and let some coolant out?
Honda-Tech Member
Joined: Nov 2001
Posts: 2,975
Likes: 0
From: Lorton, VA
Re: (davinci99)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by davinci99 »</TD></TR><TR><TD CLASS="quote">any other ideas?
</TD></TR></TABLE>
what, my idea isnt good enough for you?
92civeg: you loosen the nut on top of the thermostat and let bubbles out until there's just a steady stream of coolant coming out, then tighten the nut.
</TD></TR></TABLE>
what, my idea isnt good enough for you?
92civeg: you loosen the nut on top of the thermostat and let bubbles out until there's just a steady stream of coolant coming out, then tighten the nut.
Trending Topics
Honda-Tech Member
Joined: Nov 2001
Posts: 2,975
Likes: 0
From: Lorton, VA
Re: (davinci99)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by davinci99 »</TD></TR><TR><TD CLASS="quote">got it thanks</TD></TR></TABLE>
it worked?
it worked?
Honda-Tech Member
Joined: Nov 2001
Posts: 2,975
Likes: 0
From: Lorton, VA
Re: (davinci99)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by davinci99 »</TD></TR><TR><TD CLASS="quote">yeah it worked ,sorry if you thought i didnt believe you i just wanted some other ideas so i didnt have to post like 99 times with dumb questions. thanks again
</TD></TR></TABLE>
no prob.
</TD></TR></TABLE>
no prob.
Thread
Thread Starter
Forum
Replies
Last Post
E-spec Tuner
Tech / Misc
15
May 29, 2004 10:30 AM
