so i took my car to get tuned. plugged in the new p72 with hondata i threw a CEL and would only rev to 4500 rpm then my tuner said that hondata could not connect to his computer. we tried 2 other hondata units and they didnt work.

 

sounds like a bad solder joint in the socket

 

limp mode. what two other units?? two other hondata? then it's him...j/k

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Garage 808 Hatch &raquo;</TD></TR><TR><TD CLASS="quote">sounds like a bad solder joint in the socket</TD></TR></TABLE> is this an easy fix????????

 

put the ecu into another car and see if it does this. is it an s300, s200 or s100? if its a 200 or 100, it may be a bad burn, or a chip installed backwards. or as earlier stated, a bad solder on the chip socket or the 4 prong for the hondata

 

its a s200 and we have not tried that. is there a place i can send it so they can fix it.

 

s200?? time to upgrade.

 

its just all motor s300 would be over kill

 

try the ecu and hondata in another car, and see if it still does it. try and get another chip burned for you as well, sounds like either a bad burn on the chip or a bad solder joint on either the chip or 4pin

 

im trying to get somebody to check it out if not is there any places from this site i can send it.

 

Are you sure it is a s200 and not a older staged system? What does the serial number on the back say?