Distributor Problem w/ car not staying running.
Thread Starter
Honda-Tech Member
Joined: Sep 2002
Posts: 248
Likes: 0
Distributor Problem w/ car not staying running.
95 civic ex coupe
with a 96 b16a2 motor completly rebuilt ( JE psitons and eagle rods)
OBD 1 p28 computer remprogrammed by Katman
I have a b16a2 motor that i recenlty just put in. I'm 99% sure my timing belt was installed right. I checked my plugs and have the just bought the right fuel hose for the swap. My question is my car won't stay started unless i hold the gas pedal at 3000 rpm then it runs smooth, but if I let off it dies out and stalls. It is also hard to start. Can this be caused by the distributor not being advanced or retarded right? Or am I dealing with something else?
with a 96 b16a2 motor completly rebuilt ( JE psitons and eagle rods)
OBD 1 p28 computer remprogrammed by Katman
I have a b16a2 motor that i recenlty just put in. I'm 99% sure my timing belt was installed right. I checked my plugs and have the just bought the right fuel hose for the swap. My question is my car won't stay started unless i hold the gas pedal at 3000 rpm then it runs smooth, but if I let off it dies out and stalls. It is also hard to start. Can this be caused by the distributor not being advanced or retarded right? Or am I dealing with something else?
Thread
Thread Starter
Forum
Replies
Last Post
TheMuzz
Honda Accord (1990 - 2002)
3
Apr 14, 2014 02:36 PM
b20vtech
Honda Civic / Del Sol (1992 - 2000)
14
Feb 6, 2009 04:20 PM
rrm5
Honda Civic / Del Sol (1992 - 2000)
3
Mar 29, 2007 04:36 PM