just wanna get an idea of how much im gonna spend
cause im planning on doing this by next week.

also anyone know a good machine shop in the nyc area??

 

I'm not in nyc, but I just rebuilt a b16 and the machine shop was going to charge $50 for a bore align/hone. It came to $150 to overbore by 0.020, and $50 to change the pistons on the same rods (which had to be modified). No idea about a complete install

 

bore and hone is usually 15-20 per cylinder. to install pistons and rods its usually 400-600.00. thats basically assembling a complete bottom end.

 

shops were going to charge me in the hundreds to change piston/rods, but i got hooked up for $20 at a different shop which was going to charge me $80 at first.