Hi guys...
can you please check out my catch can setup.. Is it possible to install the cans as shown in my pic??? Sorry for the very bad graph :-) I did that in 2 minutes



C1-C3 are the cans
IM is intake manifold

 

Yes, but you can do it much simpler. You only need one catch can. I run a Moroso breather can. The block breather an the valve cover breather go into the Moroso. From the bottom of the Moroso breather, I have a -10 line running to a fitting on my Moroso Pan. The top of the Breather has a K&N filter to vent

 

Thanx for reply.. The problem is that I have 2 lines coming from the valve cover So I´ll need a second can if I would go with a moroso can right??

 

You can just use a T fitting to merge the lines together. You don't need to mess with more than 1 can. One is plenty.

http://www.moroso.com/catalog/...13400

 

ok thanx for the infos.. last question.. I´ve got already a greddy oil catch can without a breather so I´ll use a T fitting to connect all libes to the can but where´s the best place to connect the catch can to.. To the itake manifold or Intake pipe? I´ve got a turbo system and I´ve no idea where to connect the line coming from the catch can to.. (the green one shown in my graph)