Is anyone running these? Camp1320's deal is too good to pass up for bearings and T Washers. BTW they will be going into a D16A6 w/ shot peened rods, Y8 pistons, delta 272 cam, some head work (P&P, springs, valves, etc..) and a turbo

 

I use them, great quality

 

were their any clearance problems? like to thin/thick when plasigauged?

 

no clearance problems, they fell right where i wanted them; .0015 and .0017 on #3

 

I'd have to say that well over 50% of people that rebuild thier motors use ACLs. tons of 500hp+ cars out there rocking them. I just installed some the other day in my motor and went smooth as always. Simple, cheap, and proven!