Will the Rev Hard iron/tubular non-ac manifold accommodate a Tial 38mm wastegate?
Here's the link for it, along with a picture.

http://www.motormatrix.com/irnonmancivb.html



Also a question about wastegates. If I buy a wastegate, say a Tial 38mm with a 10lb spring (0.7 bar), would the wastegate ONLY allow the turbo to spool and generate up to 10 lbs??? Or would I need to buy a boost controller regardless?

Thanks,
Tim

 

itll boost until 10 lbs and then begin to bleed off exhaust.


As far as the wastegate fitting it should fit the flange.

 

The spring rates are just what the lowest boost it holds. You can always increase boost with a boost controller, but you cant' go lower than the spring.