4th gen H23A1 engine..when I remove the lines is it going to spit out fuel? etc?? Any suggestions/hints on replacement is greatly appreciated!!

 

bump

 

Once you loosen the banjo bolt on the filter a little fuel will spray out...nothing to bad though. Once you do that your fuel pressure will be relieved and you can replace the filter in seconds.

 

dude, i was like 1/4 of the way down the page, why the hell did you bump it????

 

Because i'm doing it TONIGHT. I needed to get some answers.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 3gLudeH22A &raquo;</TD></TR><TR><TD CLASS="quote">Once you loosen the banjo bolt on the filter a little fuel will spray out...nothing to bad though. Once you do that your fuel pressure will be relieved and you can replace the filter in seconds.</TD></TR></TABLE>

Do you recommend removing the bracket bolts first or the lines?

 

unscrew your fuel cap 1st... and dont light a match or something while u do it... thats the only pointers u need

 

bumping it like 5 lines isn't going to matter that much, patience is a virtue, it was dumb luck that someone repsonded

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Boosted97Lude &raquo;</TD></TR><TR><TD CLASS="quote">bumping it like 5 lines isn't going to matter that much, patience is a virtue, it was dumb luck that someone repsonded</TD></TR></TABLE>

 

HA!!! you think twice about bumping a post only 30 min old that is only 1/4 way down next time

and no, this is not an abuse of power, rather a learning experience for a new member