My 94 EJ1 is missing 1 of the bolts. Engine is the D16Z6. Bolt is an M10 1.25 flange head. The depth appears to be 40mm. Any suggestions on where to find a replacement?

 

Dealer. They are a couple bucks each.

One is M10x35, the other three are M10x50

 

Thank you. Didn't know if the dealer would still have the part anymore

 

They're used in a wide range of years, so I'm sure they're still available.

When things aren't available, try to figure out what it is from the parts fiche, then look for something similar here: https://www.belmetric.com/

Most of the stuff on these cars is JIS small wrench.

Here's your 35mm:


and the 50mm is likely partial thread:

 

Thanks. Local dealer had the bolt I needed. Just had to show them a pic of which one was missing.

 

Please be kind and share the information that you found (such as the Honda OEM Part# that was in the peach bag you purchased.) Please give back so that others can benefit as well. That's what this forum is about.

 

Can you please tell me what size socket does it take

 

An M10 will normally use a 14mm wrench or socket