Hey guys, found i had a cracked runner on my custom manifold yesterday. Have got it all fixed but would like to see some pics of any supports people have made to try and stop it happening again.

 

Goes from the bottom block bolt to the turbo.

 

That looks good. So where does it bolt to the block? have you tries it out yet?

 

It bolts to where the bottom bolt of AC mount went into the block.

 

Ditch the wire mesh, it's costing you power.

 

mesh filter and flex pipe wastegate dumptube were only temporary and have been gone for months.

as it is now:

 

hey man not to get off topic but why are your strut towers cut out? air flow?
Thanks

 

from when I used to have hydrolics

 

haha

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Slammd Sol &raquo;</TD></TR><TR><TD CLASS="quote">from when I used to have hydrolics </TD></TR></TABLE>

key word used.. thats good. looks good.

 

WHAT A SSAUTOCHROME, MAnifold CRACK

NO FUCKEN WAY!!!!!

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Quad-Damge &raquo;</TD></TR><TR><TD CLASS="quote">WHAT A SSAUTOCHROME, MAnifold CRACK

NO FUCKEN WAY!!!!! </TD></TR></TABLE>

hey; read the thread dipshit

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Quad-Damge &raquo;</TD></TR><TR><TD CLASS="quote">WHAT A SSAUTOCHROME, MAnifold CRACK

NO FUCKEN WAY!!!!! </TD></TR></TABLE>

ROFL.. are you jokin? yes its an SSAC.. Its braced and been on for 6 months now with NO problems. For the $70 shipped i got it for from the FI classifieds you cant beat it. Esp. the tubular design.

 

I have a brace exactly like slammed on my b18c ssac manifold, 5 months now, no cracks, best $85 i've spent...

 

can u still use the brace with ac?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by oxSLEEPERxo &raquo;</TD></TR><TR><TD CLASS="quote">can u still use the brace with ac?</TD></TR></TABLE>

 

Im sure you could make it work

 

i have read before about the bracing, and this verifies it. awesome and looks pretty explanatory on how to brace it up, just look at the picture. good job man, and way to save some $$$

 

Agreed that is the way im going to do mime. Thanks for all the help guys i just have to figure out a way to get at the nuts that hold the turbo on. Think i will have to take the compressor housing off.

 

OMG. A thread where people utilized conscious thought in re SSAC manifolds. I thought this was HT???

What the **** is happening to my circus??

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by J. Davis &raquo;</TD></TR><TR><TD CLASS="quote">OMG. A thread where people utilized conscious thought in re SSAC manifolds. I thought this was HT???

What the **** is happening to my circus??</TD></TR></TABLE>

ahhahahhaha werd