Could you please confirm me where to connect the 2 wires than come from the MSD box (White and red).

The White go to the White/Blue and the red to the black/Yellow
But this last one need to be connected in the red circle or blue circle on the picture below please?



Thank you

 

Red circle if I remember correctly. I used a small bolt and nut to connect the wire from the MSD and the wire in the red circle. Little loctite for reasurrance on the bolt and good to go

 

Figure one shows you how to wire the MSD box with internal coil and Figure two shows you how to wire the MSD box with External coil

 

Thank you.
I use a MSD box (digital 6)
After wiring it will be difficult Remove the MSD cap, Unless I make connectors?

 

Try it and find out.

 

dont forget to cut the wires for 4 cyl

 

drill a small whole in the dizzy cap and put a plug wire on for easy remove

 

What do you mean please?

 

There is already a hole on MSD Cap, I need to put 2 plugs wire

 

The MSD wiring on the plug, has 2 wire loops. Should be blue and pink. They are in a loop because by default its triggered for 8 cylinder engines. You need to cut them both for 4 cylinder engines. After u cut them, isolate them with tape.

 

Ok thank you, my digital 6 is not brand new and I blue and pink wires are already cut

 

Ok it works correctly