just installed new clutch and noticed that passenger axle and half-shaft r both leaking oil can i just tap in the axle to get it to sit right and could it be that it wont go in gear cause the axle is not in all the way? thanks ahead of time for the replies!

 

When are you having problems putting it into gear: when the car is running, off, or both?

 

when the car is off it goes in fine but when on i have to force it in really hard but it doesnt grind and it still drives. thanks for any input!

 

Since it is only difficult with the car running, your clutch is not fully disengaging. Try bleeding the slave cylinder.

 

your axle seals are probably leaking...

 

i will try bleeding the slave cylinder and yeah my axle seal was leaking cause it was too full but wont get a chance to workon it till tomorrow i hope. will repost later. Thanks for the suggestions much appreciated!