I was wondering what the best setup is on my apexi vtec controller. Like where to put my vtec engagement point at and **** like that. If anyone could help I would greatly appreciate it. Thank You!

 

Show me a dyno graph and ill show you good settings to put.

 

i got a 2000 honda civic si with the b16a2 engine, and its pretty much stock, except for a header, and cold air intake, and an exhaust

 

Then keep the settings stock. Honda had a pretty good idea where to set vtec for a stock motor and there still in buisness, they must have done something right.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Luserkid &raquo;</TD></TR><TR><TD CLASS="quote">Then keep the settings stock. Honda had a pretty good idea where to set vtec for a stock motor and there still in buisness, they must have done something right. </TD></TR></TABLE>

werd

 

i bought the controller used, so i have no idea where the settings would be. what should i set the wide and narrow throttle at and stuff

 

All you have to do is Initial Set up and change the cylinder to 4 and then leave it alone until you take it to a dyno.