someone confirm before i start....question about my wiring job! just finished swap...
#1
Thread Starter
Join Date: Apr 2004
Location: Fairfax, Virginia
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
someone confirm before i start....question about my wiring job! just finished swap...
ok, i just finished putting a b18c (99' jdm type-r) into a 95' LS.
I used a 95' Civic SI (eg) harness and a 95' GSR dizzy/ injectors. I have a mugen mapped p28 i should be good to go right? Just wanted to double check...this engine was a little more then my b16!
I used a 95' Civic SI (eg) harness and a 95' GSR dizzy/ injectors. I have a mugen mapped p28 i should be good to go right? Just wanted to double check...this engine was a little more then my b16!
#2
Thread Starter
Join Date: Apr 2004
Location: Fairfax, Virginia
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
Re: someone confirm before i start....question about my wiring job! just finished swap... (Jester_Si
Come one people...damn. I have searched, i have assembled, now i just want to double check what i have done..........someone help me out here....
#3
Honda-Tech Member
Join Date: Mar 2004
Location: San Diego, CA, USA
Posts: 1,508
Likes: 0
Received 0 Likes
on
0 Posts
Re: someone confirm before i start....question about my wiring job! just finished swap... (Jester_Si
on non tuned ecu's if your not going to run stock, run hondata, aem ems etc or atleast a vafc at the very least.
#4
Thread Starter
Join Date: Apr 2004
Location: Fairfax, Virginia
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
Re: someone confirm before i start....question about my wiring job! just finished swap... (Jester_Si
WHAT!?!?! Thanks for worthless info that doesn't pertain to my question......and for the record...i have an s200b with datalogging that will be utilized at a later date.....
Thread
Thread Starter
Forum
Replies
Last Post
B20-T
Honda Civic / Del Sol (1992 - 2000)
3
04-19-2002 03:17 PM