Cost of Machine work.. whats some good prices?
02-09-2003, 11:26 AM
#1
Thread Starter
Join Date: May 2002
Location: Norcal
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
Cost of Machine work.. whats some good prices?
Hey guys I tried searching but didnt get much and I had a few questions... How much do shops usually charge to bore a block (just .25 to put in oversized pistons) and install pistons? Also whats the usual cost of blueprinting and balancing a block and the crank? Any info would be appreciated. Thanks. 
02-09-2003, 09:19 PM
#3
Thread Starter
Join Date: May 2002
Location: Norcal
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cost of Machine work.. whats some good prices? (wm5holla)
thats the problem theres no one around here... i just wanted to get an estimate from people who have done it before so I know how much it usually runs...
02-10-2003, 06:22 AM
#4
Junior Member
Join Date: Jun 2002
Location: Trumbull, CT, USA
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cost of Machine work.. whats some good prices? (triplet)
I just got a quote of around $400to: bore and hone the block, hot tank it, grind the rods to accept CTR pistons, and balance everything.
Thread
Thread Starter
Forum
Replies
Last Post
Touch
All Motor / Naturally Aspirated
7
10-18-2005 10:47 AM
