CEL after I start the car =T
#1
Thread Starter
Join Date: May 2002
Location: Virginia Beach, VA, USA
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
CEL after I start the car =T
I swapped a B18A into my 91 Crx SI, did the obd-0 to obd-1 conversion too, went to start it today and the motor is cranking, but it wont start! After about 5-10 seconds leaving the key on ignition, the check engine light comes on...I tried to check it, but nothing comes up. Any ideas to why the motor wont start?
also, I was told during the obd-0 to obd-1 conversion, I was told that I had to move these wires...
INTEGRA CRX
A12 ---------> B4
A16 ---------> B5
B10 ---------> B19
just wondering if thats right?
also, I was told during the obd-0 to obd-1 conversion, I was told that I had to move these wires...
INTEGRA CRX
A12 ---------> B4
A16 ---------> B5
B10 ---------> B19
just wondering if thats right?
Thread
Thread Starter
Forum
Replies
Last Post
slowcrxsib16
Honda CRX / EF Civic (1988 - 1991)
7
01-17-2007 03:41 AM