10psiLsEf2

they are manley. valves std size. dish type.

rexracer626

no actually i never did someone did though had a friend that used them in his K series i ended up buying custom rods with arps already in them thanks though!

Julio@Bisimoto

Thank you for the support, I truly do appreciate it and looking forward to the completion of your build!

It was an honer having custom parts designed by Bisimoto Engineering for an engine that had no true aftermarket support and am even more excited that you choose AEM for your engine management to fine tune your setup when complete!

Keep us updated with your project, I am sure many of us want to see it complete!

rexracer626

@rywire finished up my harness beautiful work!







my ems 4 compared to my evo 4g

Ultra_Shane

Any updates on the interior harness?

EF_SI89

Any more pic. of the f2b build?

miked123

iTrader: (1)

Hey man real curious to the engine fitment for the f2b in a Rex. Are you gonna have to notch the frame rail on the driver side ? I'm also about to do this over the winter and have the bisi h2b/f2b kit

2.3h2b

Nice project you have there.
nice swap choice not to many f20bs out there I have one in a eg with b16 trans check out my build thread the hybrid section.Nice little motor f20b is a high revving screamer if I had to guess my car is a low 13 possibly 12 sec on slicks trapping around 105ish based off of cars I ran were I shut off by the end off street 1/4 mile .