JDMstormtrooper

whats up guys, so im doing an all motor poormanstyper build and i have this problem stuck in my mind for some reason.

ok gsr block with b16 head, skunk2 pro series stage 3 cams, skunk2 pro series valve springs and ti retainers, supertech b16 pistons 11.1 comp.

will i be any danger with the piston slapping the spark plug and/or valves with this part list and the mental note of the deck height of the block and b16 head

RICKSAUTOMOTIVE

most likely not. IDK the cam specs exactly but if you use a .040 head gasket, and your pistons are dome type pistons, and you have a deck clearance of -.002 inches you should be fine. personally i would use darton dry sleeves bored to 89 mm (3.5093 inches) with a step deck of .002 inches and cometic MLS head gasket (.040) and ARP head bolts for this build. what are you planning on using for connecting rods? i would use K-1 connecting rods

JDMstormtrooper

the cam specs are some where around .278 exhaust and .274 intake give or take a couple. Also i was going to use eagle h beam rods