JDMCL

Hi, so i recently purchased a set of ek4 4door power folding mirrors and i ran into a little issue. I was trying to run the wires through the door to the cabin but instead of there being a grommet with wires being ran through it was a connector. So there was no way around the connector because its flush with the hole rater than a dx just having the grommet with the speaker runing through it. So I'm looking to see if anyone here has done this to there lx or ex 4 door/coupe and could lead me where too run the wires. Please help lol and any help is greatly appreciated in advance.

JDMCL

Bump

JDMCL

Bump please help

deschlong

iTrader: (8)

If I were you, I'd get some male and female connector pins with a bit of pigtail, and connect your wires to that, then run them through the connector. Very clean and seamless install.

angrysmileyface

Connectors and pins are the easiest way to do it. When I added the heated mirrors to my harness (Still in progress, harness done, mirrors just need elements), I used the pins and connectors from a scavenged harness and just soldered the pigtails to my wires.