3 wire to 2 wire iacv problem
#1
3 wire to 2 wire iacv problem
Ok here it goes I have a 2000 civic y8 obd2b it was auto converted to manual was running auto computer for a while car was fine so I wanted to chip and tune so went to obd1 on 2 step with vtec so I did the 3 wire to 2 wire conversion I start car up and idles high I go to push gas and rpms go dead but car is still running so I drive car and idle goes back down only wen up to temp only on start up was idle high so I look it up rpm problem and found another guy with same problem he said jus run a wire from dizzy to cluster and I'll be fine so got lazy didn't do now my computer got fried was wondering if it was becuase my rpms weren't working or did I have a bad jumper harness or my computer jus took a dump? Jus don't want to waste money on another computer before problem is fixed thanx
Thread
Thread Starter
Forum
Replies
Last Post
Pfieff
Honda Civic / Del Sol (1992 - 2000)
4
12-02-2003 09:47 AM