Offical eH squad list.
I already know about the bracket thats keeps the seats aligned. I need to know about the mounting brackets for the rear/top cushions. They have dimples in the floor already there, but if you drill them out, the metal is too thin to tap it out, so I need to know if there is a different way I can go about doing this or if I should just weld it.
Honda-Tech Member
Joined: Jan 2003
Posts: 2,312
Likes: 1
From: Sacrament ho, California, United States
I already know about the bracket thats keeps the seats aligned. I need to know about the mounting brackets for the rear/top cushions. They have dimples in the floor already there, but if you drill them out, the metal is too thin to tap it out, so I need to know if there is a different way I can go about doing this or if I should just weld it.
Thread Starter
Honda-Tech Member
Joined: Jan 2004
Posts: 10,475
Likes: 0
From: Working in the NRBG, Garage
I already know about the bracket thats keeps the seats aligned. I need to know about the mounting brackets for the rear/top cushions. They have dimples in the floor already there, but if you drill them out, the metal is too thin to tap it out, so I need to know if there is a different way I can go about doing this or if I should just weld it.
thank you guys.
trip got pushed back till jan due to expensive *** airfare. but im looking forward to the cali trip. too bad for everyone that im going to see isnt going to see my beard lol
trip got pushed back till jan due to expensive *** airfare. but im looking forward to the cali trip. too bad for everyone that im going to see isnt going to see my beard lol
Honda-Tech Member
Joined: Jan 2003
Posts: 2,312
Likes: 1
From: Sacrament ho, California, United States
I'm jealous man, I can't wait to hit a track event.
DO IT!
I finally finished pullying out all the wiring from Analyn. Going to finish removing the brakelines from the engine bay.
CALI>ALL
I finally finished pullying out all the wiring from Analyn. Going to finish removing the brakelines from the engine bay.
Thread Starter
Honda-Tech Member
Joined: Jan 2004
Posts: 10,475
Likes: 0
From: Working in the NRBG, Garage
i've taken off the whole front end and i'm going to start pulling the motor so i can use that tranny on the four door. from there i pull out the dash.
Honda-Tech Member
iTrader: (1)
Joined: Mar 2004
Posts: 1,695
Likes: 0
From: Sac. Vtecstyle norcal, ca, United States
So I read the rules and how to become a member. Correct me if I'm wrong. I need to make a page on appearance and cosmetics of my eh. Then I have to pm the first ten peeps on the list with the link of my thread. So right now my car is not looking so hot. Just wondering how do you guys go about judging. Is there a guide line or do you guys just say thumbs up thumbs down. Just wondering. Might what to join. Thanks




