ichbinsobose

I looked at all the ecu pinouts, and my wire colors DO NOT match Whatever, i got most of it done I think.
I have one question still though.... where the expletive does the analog1 (which I intend to use with crome) go? D14 says everyone...should be red/white. Its not. It's green/orange and reads ~.2 - .5 V when I turn the car on. Questionable.
When I wire it in with either the green/orange wire, or the only red/white wire in my ecu plugs, the lc1 does the heat up mode blink correctly...and then throws error code 4.
4..4...4....4....4....4....44...4.4.4.4.4.4.4..4.4 aaaagggggggggggh
Cant figure this sucker out, any help?

ichbinsobose

laziebun

http://www.tleone.com/index.ph...d=104


try that it has all the colors and pin outs....good luck