One of my bolt to hold the trailing arm bushing snapped into the threads, and the bolt that holds the arm for alignment is broken too. what should i do? need answers. should i drill it?

 

spray the broken bolts with wd40 or pb blaster so the threads are penetrated then drill a small hole in it, and then use a screw extractor aka easy out. Don't break either drill bit or screw extractor in the bolts because you will be Sh*t of lucky if you do.

Last buy a tap kit to retap threads so this won't happen again.

 

I would invest in MAP gas or get it towed to a shop with an OXY/ACET. torch. Heat will aid in the process of removing it.

 

k thanks guys