Notices
 
Search: Posts Made By: 90civic-ZC
Showing results 1 to 25 of 500
Search took 0.45 seconds.
01-27-2013, 01:01 AM
Replies: 6
Views: 820
Posted By 90civic-ZC

Re: 91 std hatch not turning over

Sorry....thermostat ground.....read it wrong. But even if just the tranny ground isn't hooked up the starter will more than likely not turn over.
01-27-2013, 12:58 AM
Replies: 6
Views: 820
Posted By 90civic-ZC

Re: 91 std hatch not turning over

If the radiator ground doesn't have a good ground or none at all the ecu is basically dead.
01-25-2013, 05:47 AM
Replies: 21
Views: 13,878
Posted By 90civic-ZC

Re: NEED WIRING HELP!!! Obd0-obd1 ef

When you turn the key to on does the CEL stay on or clicks off after 2 seconds?
01-21-2013, 06:01 AM
Replies: 14
Views: 1,155
Posted By 90civic-ZC

Re: What do you get for MPG's?

90 civic hatch, 16's 215's, lowered (about two inches), obd0 DOHC ZC, lightweight flywheel, stage 1 clutch, 91 si tranny, and 2.25 inch cat back, battery relocated, no power steering or A/C, intake....
01-21-2013, 05:44 AM
Replies: 12
Views: 4,995
Posted By 90civic-ZC

Re: d16z6 swap in crx no spark

And just my two cents, don't fuck around with the msd crap. It's more shit to go wrong and to fix and trouble shoot.
01-21-2013, 05:40 AM
Replies: 12
Views: 4,995
Posted By 90civic-ZC

Re: d16z6 swap in crx no spark

Ignitor could be bad....any codes? Have you made sure your home made dizzy jumper is actually making a good connection?
12-24-2012, 10:22 PM
Replies: 9
Views: 793
Posted By 90civic-ZC

Re: JDM Spec S1 Cable Tranny clutch pedal squeecking

Mine does that too bruh, but I was just blaming it on my stage 1 clutch......I personally just have the radio up to where I can't hear it, but try some WD40 or maybe some all purpose...
10-29-2012, 04:54 AM
Replies: 8
Views: 7,211
Posted By 90civic-ZC

Re: which head gasket to use on a JDM B20b with P8R head

Yes, for a low compression B20 P8R head......bigger (vtec) intake valves and bigger combustion chamber. So yes I curious about which head gasket to use, either for the head or buy it for the block. ...
10-22-2012, 05:23 AM
Replies: 8
Views: 7,211
Posted By 90civic-ZC

Re: which head gasket to use on a JDM B20b with P8R head

See I've thought about that, but didn't know if it would lower the compression. Do you know how much I should shave the head to get it back to the 9:5-9:6 CR?
08-23-2012, 08:35 PM
Replies: 4
Views: 637
Posted By 90civic-ZC

Re: B series transfer

Well if it's a hydro then you need to convert it for cable. If cable, then that's money you can put towards mounts or a conversion harness.
08-23-2012, 12:09 PM
Replies: 9
Views: 2,386
Posted By 90civic-ZC

Re: b18 swap not starting with key

I guarantee it's the ignition switch also.
08-16-2012, 05:25 AM
Replies: 8
Views: 1,911
Posted By 90civic-ZC

Re: Frankenstein ZC tranny - has it been done?

Yes, they are all interchangeable.
08-11-2012, 08:57 AM
Replies: 4
Views: 821
Posted By 90civic-ZC

Re: I Need a tps for my 88 crx help

Junk yard, Ebay, craigslist, the for sale up top. Blox sells TPS's.
08-10-2012, 04:58 PM
Replies: 15
Views: 2,034
Posted By 90civic-ZC

Re: Any tricks for getting to the O2 sensor, 91, 1.5 hatch?

Yep, the old handy dandy wrench is what i also used. Might try putting the torch to it if you have one.
08-10-2012, 04:54 PM
Replies: 12
Views: 5,519
Posted By 90civic-ZC

Re: motor oil in transmission?

Like they said, just to throw in my two cents while i wait for my tall glass of cooled genuine draft of Bud Light, I use GM synchro mesh friction......(I believe it's called). You can only get it...
08-10-2012, 04:43 PM
Replies: 13
Views: 10,409
Posted By 90civic-ZC

Re: D15b1 timing issue on my 89 STD Hatch

Do what you feel like man, it's your money.....your car. Personally if I take the tension off of a old belt, I replace it regardless unless it's brand spanking new and i for some reason got the...
08-10-2012, 04:33 PM
Replies: 3
Views: 1,157
Posted By 90civic-ZC

Re: Need electrical help!

Well if a fuse keeps blowing it usually means there's a break in the current and it's somehow arcing or shorting itself out as you said. Other than that the only advice i can give is follow the wires...
08-10-2012, 05:35 AM
Replies: 1
Views: 539
Posted By 90civic-ZC

Re: ENGINE HARNESS 89 SI

Yeah, the for sale at the top of the page, craigslist, ebay, junk yards. PS, read the FAQ's about posting.
08-10-2012, 05:28 AM
Replies: 3
Views: 1,109
Posted By 90civic-ZC

Re: D16a6 issues

Have you checked to see what code its throwing when the CEL comes on?
08-09-2012, 08:07 AM
Replies: 5
Views: 660
Posted By 90civic-ZC

Re: question about brakes and spindels

Have you looked in the FAQ's? There's a write up about upgrading your brakes.
08-09-2012, 08:02 AM
Replies: 22
Views: 1,722
Posted By 90civic-ZC

Re: Binding Issues

Exactly what i was gonna ask, check for the dust guard ring.
08-09-2012, 05:20 AM
Replies: 4
Views: 717
Posted By 90civic-ZC

Re: starting problem on 90 hatch.

Almost sounds like a bad ignition switch.........and go to the junk yard and get yourself the other starter bolt. Hell, you could do a five finger discount for the damn bolt.
08-08-2012, 06:30 PM
Replies: 11
Views: 15,677
Posted By 90civic-ZC

Re: b18c swap guide?

Really a B20 is too big size wise when you want a B18 that is less than a hundred pounds different from the other? You sound like you just want something simple with decent power. A B20, B18, or dual...
08-08-2012, 06:04 PM
Replies: 21
Views: 13,723
Posted By 90civic-ZC

Re: DOHC ZC all motor options?

Really it bleeped out q u e e f y? Lame.....
Showing results 1 to 25 of 500
 


 
Forum Jump


All times are GMT -8. The time now is 04:49 AM.