Search: Posts Made By: Accordin2me
Showing results 1 to 25 of 68
Search took 0.23 seconds.
Forum: Tech / Misc
08-03-2011, 08:25 AM
Replies: 5
Views: 1,831
Posted By Accordin2me

Re: help!!! on vtec pressure switch bolt torque

I believe its around 7-11 ft lbs
05-18-2011, 08:58 AM
Replies: 11
Views: 19,633
Posted By Accordin2me

Re: Vibration during acceleration

Did you check the backing plate behind the rotor? They always seem to migrate towards the rotor by magic during frontend work.
05-12-2011, 08:28 AM
Replies: 19
Views: 4,426
Posted By Accordin2me

Re: How do i make it faster? NOT powerful

I really hope your not serious. If your looking for more power, build the engine. If your looking for more "pull" swap the tranny. Theres no "Hidden power" in any engines I know of with the exception...
04-23-2011, 06:09 AM
Replies: 6
Views: 6,908
Posted By Accordin2me

Re: change fuel pump?

1990 and up you need to drop the tank but there is panel under the back seat to disconnect the pump from the harness. Tit job shouldnt take more than 2 hours.
04-19-2011, 06:01 AM
04-18-2011, 10:41 AM
Replies: 5
Views: 1,654
Posted By Accordin2me

Re: What auto tranny fluid to use in 1st gen crx?

They take appox. 3 qts of dex 2 or 3 your choice. Same for the 1.3 and 1.5
04-18-2011, 08:28 AM
Replies: 19
Views: 2,535
Posted By Accordin2me

Re: 95 Accord F22b Swap and Boosted Wont go past 5k without fuel cut

Jump the 2 pin orange connector under the pass side kick panal and turn the ignition to on, then count the flashes on the cel its like morse code kinda
04-17-2011, 06:29 PM
Replies: 8
Views: 2,206
Posted By Accordin2me

Re: 94 accord lx not reving past 3500

If the distributor was 180 out of phase the engine woulndt even start let alone run...
Forum: Tech / Misc
04-12-2011, 06:36 PM
Replies: 2
Views: 2,008
Posted By Accordin2me

Re: Will improper alignment damage ball joints / tie rods?

It'll cause a good amount of vibration but it shouldnt wear the componants past there service limit, just keep an eye on it. Especially the tires, just get her aligned it cant be more than $60-$80...
04-09-2011, 02:04 PM
Replies: 12
Views: 24,058
Posted By Accordin2me

Re: how to install harmonic balancer bolt

If you have an old serpentine belt lyin around you can have a buddy hold it tight around the crank while you torque it.
04-09-2011, 01:55 PM
Replies: 36
Views: 92,134
Posted By Accordin2me

Re: f22b1 vtec, is it really that bad?

Dude, why you gotta hate on the F? Do you remember when ANY honda engine was considered a joke? I understand the H has more power but I think the F has more potential. C'mon the thing CRAVES boost....
03-07-2011, 09:42 AM
Replies: 2
Views: 821
Posted By Accordin2me

Re: 01 Accord Engine run bad

Shouldnt this be in another thread?
03-01-2011, 12:48 PM
Replies: 5
Views: 7,629
Posted By Accordin2me

Re: 95 accord tie rod replacement question????

Pepboys told you the tierods are bad and they still aligned it? And you got an alignment with a known bad outer? Not wise my friend.
02-10-2011, 08:50 AM
Replies: 10
Views: 15,215
Posted By Accordin2me

Re: Short Shifter bad for transmission?

They either A): Do it right and buy a shorter, aftermarket stick. Or B): Grind it down and re-tap the threads (Not the best Idea).
02-10-2011, 04:32 AM
Replies: 10
Views: 15,215
Posted By Accordin2me

Re: Short Shifter bad for transmission?

IMO they tend to wear synchros b/c the shorter throw allows less time for the input-output speeds to match. It really depends how you drive the car. If you're the type that shoves the shifter into...
02-09-2011, 12:06 PM
Replies: 30
Views: 35,157
Posted By Accordin2me

Re: 1992 Accord wont stay running

I was under the impression you replaced the entire ignition lock cylinder with the switch. Ignore post. Will it run with the throttle open?
02-08-2011, 12:08 PM
Replies: 30
Views: 35,157
Posted By Accordin2me

Re: 1992 Accord wont stay running

Lol @ PGTMatt, Dont break the keyboard killa. Did you get the new ignition switch "married" to the ecu? I cant remember if the motor will crank with a new one but I know it wont run.
02-03-2011, 08:09 AM
Replies: 15
Views: 5,981
Posted By Accordin2me

Re: F22B1

Get a chiltons or helms manual. They cover just about everything bumper to bumper.
01-20-2011, 10:03 AM
Replies: 3
Views: 3,976
Posted By Accordin2me

Re: Crazy idle while turning the steering wheel while parked???

Im not sure if honda uses them as I never thought to look but try the power steering pressure sensor its either on the rack or high side hose. It'll look like an oil pressure switch.
Forum: Northeast
01-19-2011, 09:30 AM
Replies: 38
Views: 3,073
Posted By Accordin2me

Re: ***Massachuetts*** Post Your Rides

Hey La where bouts the 978 you located?
01-17-2011, 09:29 AM
Replies: 7
Views: 2,013
Posted By Accordin2me

Re: need some info on my accord

Your too fast 4 me muffin lol. Ya I didnt know the 6th gens came with a 1.8 sounds a tad under powered for that chassis.
01-17-2011, 09:00 AM
Replies: 7
Views: 2,013
Posted By Accordin2me

Re: need some info on my accord

Gen 6, Chassis code is 4th 5th and 6th digits of vin. And btw its either a 2.3 or 3.0 no 1.8l.
Forum: Tech / Misc
01-17-2011, 07:28 AM
Replies: 9
Views: 930
Posted By Accordin2me

Re: BIG Starting and running issue!!

Sounds like a fuel issue, check cranking and running pressure.
Forum: Tech / Misc
01-15-2011, 07:49 AM
Replies: 37
Views: 3,201
Posted By Accordin2me

Re: idling is totally unnecessary

Most "real" hybrids (i.e. not IMA) Have a coolant tank that stays at operating temp for up to 3 days for just that purpose as well as instant heat. Total PITA to replace too.
01-11-2011, 07:52 AM
Replies: 57
Views: 995,373
Posted By Accordin2me

Re: Check Engine Light codes (CEL) Diagnostic Trouble Codes (DTC) Malfunction Indicat

Check the wire harness in the pass. front wheel well under the splash shield. It tends to rot and cause all kinds of funky a/c problems.
Showing results 1 to 25 of 68
 


 
Forum Jump


All times are GMT -8. The time now is 03:53 PM.