Honda-Tech - Honda Forum Discussion

Notices
Search: Posts Made By: zzzjoe
Showing results 1 to 7 of 7
Search took 0.23 seconds.
Forum: Honda Civic (2001 - 2005)
06-15-2010, 05:02 PM
Replies: 30
Views: 92,819
Posted By zzzjoe

Re: 2001 Honda Civic EX, broken timing belt

One of the guy's in my office had his belt go, and I told him it was going to cost him big. with the interference engine he had to bend some valves at least. He took it to a shop, and the mechanic...
Forum: Honda Civic (2001 - 2005)
06-12-2010, 01:25 PM
Replies: 2
Views: 1,254
Posted By zzzjoe

Re: "Rattling" noise, looking for input

I had a similar noise on my 97 accord at the same rpm's. after not being able to find anything I took it to a muffler shop. They told me there was a small crack in the weld on the exhaust pipe that...
Forum: Honda Civic (2001 - 2005)
06-12-2010, 10:23 AM
Replies: 13
Views: 1,553
Posted By zzzjoe

Re: Buddy selling me his civic

I just bought a 01 Civic LX sedan with 145,000 mi. The owner had already replaced the tranny at 75,000 so I thought I had a good deal with a young tranny. Before you buy have the tranny, and the...
Forum: Honda Civic (2006 - 2015)
06-12-2010, 09:40 AM
Replies: 107
Views: 59,122
Posted By zzzjoe

Re: How long did your Honda Civic last before having major problems?

97 5sp coupe bearings went out in the tranny at 175,000 pulled it out and had them replaced for $175. Did the clutch as long as I had the tranny out and new half shafts. not that expensive if you...
Forum: Honda Civic / Del Sol (1992 - 2000)
06-08-2010, 07:10 PM
Replies: 172
Views: 348,134
Posted By zzzjoe

Re: [FAQ] Complete DIY How To: Timing Belt/Water Pump Change on a D16Z6 - lots of pic

Good write up I did my 97 civic just out of the book. I wish I would have seen this first. I would suggest while you have the valve cover off check and adjust your valve clearance if needed
Forum: Honda Civic / Del Sol (1992 - 2000)
06-08-2010, 06:09 PM
Replies: 9
Views: 9,007
Posted By zzzjoe

Re: Removing and Replacing Knuckle, difficult?

The spindle on the ball joint is a taper fit into the LCA. Make sure both parts are clean the should go back in without a problem. If the nut won't screw up the threads I put my jack under the LCA...
Forum: Honda CRX / EF Civic (1988 - 1991)
06-08-2010, 05:41 PM
Replies: 10
Views: 1,182
Posted By zzzjoe

Re: temp. past High...help

I replaced the radiator on my Civic refilled it, started it up, drove down hill 3 blocks, at the stop sign my temp gage was up to the H. It turned out to be air in the system once I got it out it...
Showing results 1 to 7 of 7


 
Forum Jump


All times are GMT -8. The time now is 05:51 AM.