?Wiring Two O2 Sensors Into One
#1
Thread Starter
Join Date: Feb 2002
Location: Alexandria, VA, USA
Posts: 826
Likes: 0
Received 0 Likes
on
0 Posts
?Wiring Two O2 Sensors Into One
Okay, the search couldn't get me this which has been repeated a bunch of times - can you go ahead and wire both O2 sensor wires together on the output of a single o2 sensor?
I have always used two but have a jdm header i don't want to mess up with drilling and flanges, etc...
thanks, all
I have always used two but have a jdm header i don't want to mess up with drilling and flanges, etc...
thanks, all
#2
Re: ?Wiring Two O2 Sensors Into One (Ruby Civic)
Im asuming you have a oBD0 b16 swap in a 88-91 CRX/civic. My car was running rather wierd with just one of the Two wires connected to the O2. So i ran both the wires into the single wire O2 sensor. The problem almost went away, it was still kinda wierd in certain RPM's. UNder WOT it was fine, no problems, but when you are partial throttle on the highway just cruising, it does some wierd stuff. The power seems to fall out if you are at partial throttle. IT only did it under 4k RPMs so i kept it a little above 4k. This was a b16 CRX with the hasport wiring harness and stock JDM pr3 ECU.
----just what i experienced.
----just what i experienced.
#3
Thread Starter
Join Date: Feb 2002
Location: Alexandria, VA, USA
Posts: 826
Likes: 0
Received 0 Likes
on
0 Posts
Re: ?Wiring Two O2 Sensors Into One (JDM CRX)
yea, that is what i have heard also, this will be a daily driver tho so want to not have driveablility issues
it is a 91 ef sedan with obd0 electronics and b16 (pr3) ecu
it is a 91 ef sedan with obd0 electronics and b16 (pr3) ecu
Thread
Thread Starter
Forum
Replies
Last Post
import_trung
All Motor / Naturally Aspirated
5
11-12-2005 04:28 PM