no spark obd1 motor in obd2 car
09-04-2007, 05:28 PM
#1
Thread Starter
Join Date: Feb 2007
Location: saskatoon, sk, ca
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
no spark obd1 motor in obd2 car
as stated above an obd1 d series in an obd2 car with obd2 harness. Ecu conversion harness with custom wired dizz using this schematic. I am not getting spark but the motor is turning over.
This is ths schematic i used
all wires are hooked up but the two for the top dead sensor ( green and green)
because there was only one green leading from the dizz but no green from the harness. Could someone please helpme solve my problem.
Thank You
This is ths schematic i used
all wires are hooked up but the two for the top dead sensor ( green and green)
because there was only one green leading from the dizz but no green from the harness. Could someone please helpme solve my problem.
Thank You
Trending Topics
09-04-2007, 06:38 PM
#8
Thread Starter
Join Date: Feb 2007
Location: saskatoon, sk, ca
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
alright well my ignitoris getting power and still no spark. I am going to try and give it a try your way wiring them color to exact color but it doesnt seam they all correspond.
09-04-2007, 08:48 PM
#10
Honda-Tech Member
Join Date: May 2006
Location: Dublin or MN
Posts: 409
Likes: 0
Received 0 Likes
on
0 Posts
Check the resistance on your ignitor, it should be between 12.x-16.x i think, i just pulled out one that was at 10.x and put a new one in and it was good.
The other problems is likely that the diagram has the CKP+ and the CYP+ wires switched, if you switch those 2, it will fire right up.
The other problems is likely that the diagram has the CKP+ and the CYP+ wires switched, if you switch those 2, it will fire right up.
Thread
Thread Starter
Forum
Replies
Last Post
lVlemphizStylez
Tech / Misc
1
02-16-2007 07:15 AM
