Fresh b18c1 build no oil pressure help
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2006
Location: TX, USA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Fresh b18c1 build no oil pressure help
The gsr has a different cranck in it due a scorched crank so we rebuilt it with oem bearings it also has oem gsr oil pump we put it in. So we crank the car and noticed the light was on. So we hook a oil pressure gauge up and it's getting like 2-3 psi at idle we turn the car off send the oil pump back to Honda for another brand new one we get everything put back together and still no oil pressure. At this point I'm at a loss: new oil pump new oil filter new oil is there anything I'm over looking? Thanks in advance
Trending Topics
#8
Honda-Tech Member
Join Date: Sep 2003
Location: jacksonville, fl
Posts: 7,421
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fresh b18c1 build no oil pressure help
how do you know you primed it? did you pull the valve cover to make sure oil was coming into the head? sometimes the pump doesnt get a seal and cant creat oil pressure easy. i always pour oil into the pump when its new.
pull the rear hex plug a put some oil into it and the try to prime it then
pull the rear hex plug a put some oil into it and the try to prime it then
#9
Honda-Tech Member
Thread Starter
Join Date: Jul 2006
Location: TX, USA
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fresh b18c1 build no oil pressure help
well we pulled the valve cover off and it was dripping oil on to the cams but its suppose to be a stream of oil. we ended up pulling the pan and all the bearing were toast fml. im just going to put another gsr in thanks for yalls help
#10
Honda-Tech Member
iTrader: (1)
Join Date: Jun 2008
Location: Earth
Posts: 1,537
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fresh b18c1 build no oil pressure help
Did you clean the block and crank thoroughly? Were all the oil gallary's clean? Also, did you make sure the oil jet on the block deck was installed?
#11
Honda-Tech Member
Join Date: Jan 2009
Location: Albuquerque, NM
Posts: 636
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fresh b18c1 build no oil pressure help
I never got more than 6psi on a gauge while cranking the engine with the starter or more than 20psi cold at idle. After spinning a bearing u must clean all oil passage ways and pickup like ruffrhyder said too.
#12
Honda-Tech Member
Re: Fresh b18c1 build no oil pressure help
im having this same problem now I just fully built a b18c1 gsr and all brand new everything and 0 oil pressure at idle and only about 20 when on the gas at 2 1/2K WHAT COULD CAUSE THIS PLEASE HELP I HAVE CLOSE TO 10K IN THE MOTOR AND CANT AFFORD TO LOOSE IT ALL
Thread
Thread Starter
Forum
Replies
Last Post