im in the process of reinstallin my head and i need some specs... i wanst sure if all honda motors have the same torque specs for the head bolts or not. i also need torques specs for camshaft bearing cap bolts, camshaft holder bolts and cam gear torque specs. thanks alot

 

Tighten the head bolts in 3 steps, with the last step being at 72.3 Ft/Lbs, in this order to prevent warpage:

9 – 5 – 1 – 3 – 7
8 – 4 – 2 – 6 – 10

1st step: 29 ft/lbs
2nd step: 51 ft/lbs
3rd step: 72.3 ft/lbs

Camgear bolts : 37 ft/lbs
Camshaft holder bolts : 8.7 ft/lbs (Not the camshaft plates)

Couldn’t find the camshaft bearing bolts.

Hope this helps a little bit.

 

yea that helps alot, thanks

 

There was a thread on here not too long ago....it showed that torquing down the camshafts is NOT that easy....def. need to look at that.

EDIT - Here's a pic for the cams:

 

Those are the camshaft plates, below those are the actual camshaft holders that hold the camshafts to the head. Those were the ones he was talking about.

 

Those are the bolts that hold the cam caps in place. i.e. the bolts for the cam caps and the cam plates, as you're referring to them, are the same, except for the 8 bolts on the outer edge (numbers 21 through 28 in the above diagram).

 

can't see diagram