mini-me swap, need to wire vtec...
#1
Honda-Tech Member
Thread Starter
mini-me swap, need to wire vtec...
got a 95 dx hatch with an si head, and the vtec is currently wired through the shift light so when the light goes on, it activates the vtec. The car came with a P28. dont know the first thing about wiring, so i just wanted to know if someone could tell me how to wire the vtec correctly so i can stop with this ghetto shift light ****. Thanky.
#2
Senior Member
Re: mini-me swap, need to wire vtec... (VTiHatch)
VTEC wiring is faily simple. It's three wires.
First locate the VTEC solenoid (1 wire) and the VTEC oil pressure sensor (2 wires).
Simply take the Grn/Yel wire from the VTEC solenoid on the engine harness, and lead that to the A4 pinout at the ECU.
For the VTEC oil pressure switch, take the Blu/Blk wire from the VTEC oil pressure, then leads to a ORG/BLU wire, lead that to the D6 pinout.
As for the BLK wire, lead that to the thermostat ground.
First locate the VTEC solenoid (1 wire) and the VTEC oil pressure sensor (2 wires).
Simply take the Grn/Yel wire from the VTEC solenoid on the engine harness, and lead that to the A4 pinout at the ECU.
For the VTEC oil pressure switch, take the Blu/Blk wire from the VTEC oil pressure, then leads to a ORG/BLU wire, lead that to the D6 pinout.
As for the BLK wire, lead that to the thermostat ground.
Thread
Thread Starter
Forum
Replies
Last Post
05 S2K Stoner
Acura Integra
1
10-28-2004 06:40 AM