assembly of b16 tranny?
#1
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: montgomery, il, usa
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
assembly of b16 tranny?
im on the last step of rebuilding my trans. and i cant seem to get the snap ring to go in the groove of the bearing? its deff. around the outer cir. of the bearing but will not slide down. there is a gap in the seat of the casing where it seems the bearing should seat into. i just replaced the bearing and snap ring. also i cant find the torque for the case bolts? anyone have any ideas?
#2
Solbros Owns Me
Re: assembly of b16 tranny? (orioncivic)
if the snap ring is around the outer race fully, then that is not keeping the case from completely closing.
Take a long screwdriver and pry the counter shaft up into the snap ring groove(from the opening)
Take a long screwdriver and pry the counter shaft up into the snap ring groove(from the opening)
#4
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: montgomery, il, usa
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Re: (Aquafina)
case is fully seated the ring is not on top of the bearing(i broke the bearing thats why i had to replace) ill try the prying in a bit
#6
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: montgomery, il, usa
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Re: (Mista Bone)
tried that and no go. it moved closer but not enough. tried prying with a screwdriver, but that didnt work either. is it possible to have tightened the nut down too far? or pressed the bearing down too far?
Trending Topics
#10
Honda-Tech Member
Re: (orioncivic)
Just make sure prior to attempting to tighten/closing the cases that the snap ring is spread apart. If so and you have the cases mating now. Put half the bolts in snuggly. Flip it over and gently boune it on a couple thick phone books.
#11
Honda-Tech Member
Re: (Mista Bone)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Mista Bone »</TD></TR><TR><TD CLASS="quote">if the cases have mated, CS ring properly expanded but just not locked in, flip the tranny over, listen for the click.
Gravity is a wonderful thing.</TD></TR></TABLE>
Gravity is a wonderful thing.</TD></TR></TABLE>
Thread
Thread Starter
Forum
Replies
Last Post